Bel-Art F38952-0000 Owner's manual

Type
Owner's manual

Bel-Art F38952-0000 is a new safety device that can help you to break open glass ampules safely and easily. This device is made of durable plastic and features a unique design that allows you to insert up to three ampules at a time, from volumes ranging between 1ml to 10ml. The BreakSafe™ Ampule Opener is easy to use, simply place the ampules into the corresponding slots and push down on the lid until you hear a click. This will safely break the ampules open, and you can then discard the used ampules by inverting the unit over a glass disposal box.

Bel-Art F38952-0000 is a new safety device that can help you to break open glass ampules safely and easily. This device is made of durable plastic and features a unique design that allows you to insert up to three ampules at a time, from volumes ranging between 1ml to 10ml. The BreakSafe™ Ampule Opener is easy to use, simply place the ampules into the corresponding slots and push down on the lid until you hear a click. This will safely break the ampules open, and you can then discard the used ampules by inverting the unit over a glass disposal box.

BREAKSAFE
AMPULE OPENER
Catalog No. F38952-0000
Patent Pending
I N S T R U C T I O N S
Note: Inserts should be empty when installing
or removing from the ampule opener
INSTALLING DESIRED INSERT:
1. Hold the desired insert (1ml, 2ml, 5ml, 10ml) so that the volume
specification is facing the front of the ampule opener and the recessed
openings on the back edge are towards the back of the ampule opener.
2. Place the insert into the opening and then tilt the insert back at a 45° angle
inserting the back edge under theimmobilizing liplocated on the inner
backside of the ampule opener.
3. Push down gently on the front of the insert where the volume
is specified until it is locked into place and there is no movement.
REMOVING AMPULE HOUSING:
1. Holding the ampule opener in one hand, use the fingers of your other hand
to reach under opener and behind the three columns of the insert where
the ampules would be contained.
2. Pull forward on columns until the back edge of the insert is no
longer under the immobilizing lip”.
3. Grasp the front edge of the insert where the volume is specified and lift
to remove the insert from the ampule opener.
USING THE BREAKSAFE
®
AMPULE OPENER:
1. Insert up to three ampules that correspond to the specified volume.
2. Lower the lid until it is secure around the neck of the ampules.
3. With one hand push down on the Scienceware
®
logo located on the lid
until the ampules break.
To discard used ampules, hold the lid of the ampule opener open and invert
the unit over a glass disposal box or other appropriate receptacle.
Recessed openings
WAYNE, NJ 07470-1992 USA
TEL: 1-800-4BEL-ART FAX: 973-694-7199 www.belart.com 938952009
Bel-Art SP Scienceware assumes no obligation or liability for any advice furnished by it, or for results obtained with respect to these products. All such advice is given and accepted at the buyer’s risk. 05/15
© 2015. All Rights Reserved.
Bel-Art® – SP Scienceware® is a division of SP Industries, Inc.
  • Page 1 1

Bel-Art F38952-0000 Owner's manual

Type
Owner's manual

Bel-Art F38952-0000 is a new safety device that can help you to break open glass ampules safely and easily. This device is made of durable plastic and features a unique design that allows you to insert up to three ampules at a time, from volumes ranging between 1ml to 10ml. The BreakSafe™ Ampule Opener is easy to use, simply place the ampules into the corresponding slots and push down on the lid until you hear a click. This will safely break the ampules open, and you can then discard the used ampules by inverting the unit over a glass disposal box.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI