Homely Center 1*BROOMHOLDER Installation guide

Brand
Homely Center
Model
1*BROOMHOLDER
Type
Installation guide
WALL STUD INSTALLATION
STEP 1: LOCATE A STUD USING
STUD-FINDER TOOL
STEP 2: MARK THE STUD
STEP 5: INSTALL 2 CENTER
DRYWALL ANCHORS
STEP 4: DRILL ALL 4 ENTRY
HOLES
STEP 3: ALIGN BROOM HOLDER
TO THE MARKED HOLE AND
MARK ALL OTHER HOLES
STEP 6: INSTALL THE BROOM
HOLDER WITH THE SCREWS
AND SCREW COVERS
INSTALL ON DRYWALL
STEP 4: INSTALL THE BROOM HOLDER WITH THE
SCREWS AND SCREW COVERS
STEP 1: USE THE PRODUCT TO
MARK ALL 4 HOLES
STEP 2: DRILL HOLES ON THE
MARKED POINTS
STEP 3: HAMMER IN THE
DRYWALL ANCHORS
INSTALL ON OTHER
STEP 1: CLEAN THE SURFACE
WHERE THE ADHESIVE WILL BE
APPLIED
STEP 4: STICK THE ADHESIVE
PARALLEL TO THE LEVEL LINE
STEP 5: REMOVE THE THINNER
BACKING
STEP 6: ATTACH THE BROOM
AND MOP HOLDER AND WAIT
48 HOURS BEFORE USING
STEP 3: REMOVE THE THICK
BACKING FROM THE ADHESIVE
STRIP
STEP 2: DRAW A LEVEL LINE AT
THE LOCATION OF
INSTALLATION
NOTE: ONLY USE WHEN HARDWARE IS INAPPLICABLE (IE. ON CERAMIC TILES).
RECOMMENDED FOR LIGHTER ITEMS ONLY. ADHESIVE HAS A SMALLER HOLDING
CAPACITY THAN HARDWARE.
  • Page 1 1
  • Page 2 2
  • Page 3 3

Homely Center 1*BROOMHOLDER Installation guide

Brand
Homely Center
Model
1*BROOMHOLDER
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents