Sapling Auxiliary Relays Installation guide

Page 1

Sapling, Inc. 1633 Republic Road Huntingdon Valley, PA 19006 Phone: (215) 322-6063 Fax: (215) 322-8498 www.Sapling-Inc.com

Auxiliary Relays Installation Manual (V 3.0)

1. Turn power off from the master clock.

2. Remove perforated plate next to the relay board. If you are installing two auxiliary re-

lay boards, remove both perforated plates. (SMC-200-00K-1 & SMC-300-00K-1 only)

3. Install the circuit board using the screws included in the kit.

4. Attach wiring harness from CON1 on the auxiliary relay board to CON5 on the relay

board inside the master clock.

5. Turn the master clock back on.

6. Enter 8081 into the keyboard. Arrow down until the cursor is blinking on address 005.

7. Type in 008 (for one auxiliary relay board - 8 relays) or 012 (for two auxiliary relay

boards - 12 relays).

8. Press No/Cancel to return display prompt.

Installation Instructions