- 1 -
DMSG_0152_0112_V4
© Mamas & Papas (Holdings) Ltd. 2012
Dream Swing
- 2 -
COMPONENTS
DREAM SWING
Read the entire instruction before assembling and using this product. The correct
use and maintenance of your product will ensure it gives long and trouble free use. If
somebody else is using the product ensure they also know how to use it and know all of
the safety precautions. The safety of your child is your responsibility.
If any items are damaged or missing, please contact your retailer or Mamas & Papas on +44
(0)845 268 2000.
THESE INSTRUCTIONS ARE IMPORTANT. PLEASE READ CAREFULLY AND RETAIN FOR
FUTURE REFERENCE.
Toy bar x1
Jack plug x1
Swing x1
Toys x2
- 3 -
OPENING THE SWING
Grip the top of the metal tube
at the back of the swing and
rotate it until it locks into the
foot moulding.
Push the leg rest on the front
of the seat downwards until it
is in the bottom position.
Push the back rest down to
ensure that it has locked in
place
- 4 -
FITTING THE BATTERIES
Remove the two screws
holding the battery plate in
place on the left side of the
frame with a cross head
screwdriver.
Remove the cover and place to
one side.
Insert four C ‘LR14’ batteries
into the compartments.
Ensure that the battery
polarities are correctly aligned.
Refit the battery cover over
the battery compartment and
tighten the two screws.
C / LR14
C / LR14
C / LR14
C / LR14
- 5 -
ADJUSTING THE BACKREST
The backrest can be adjusted
into three different positions.
Ensure that the seat is only
used in the fully reclined
position until the child can hold
its head up unassisted.
To lower the backrest:
Lift the handle at the top of the
backrest upwards. Lower the
backrest into the new position
and release the handle. Always
check the backrest is locked
into position.
To raise the backrest:
Grip the middle of the top of
the backrest and lift upwards
into the desired position.
Always check the backrest is
locked into position.
- 6 -
USING AND ADJUSTING THE SAFETY HARNESS
Never place your child in
the seat without fitting and
adjusting the safety harness.
Opening the harness cover
Pull the front of the harness
cover upwards to access the
buckle.
Fasten the press studs on the
harness cover to close.
Always close the cover when
the child is in the cradle.
Locking the harness
Push the locking catch into
the buckle 1 until it clicks into
place. Repeat the process for
the lock on the other side.
Releasing the harness
Push the two tabs 2 on the
locking catch inwards whilst
pulling the two sections apart
3.
Adjusting the harness length
To loosen the harness feed
the webbing back through the
adjustment buckle.
To tighten the harness, pull
the free end of the webbing
outwards.
3
3
2
2
1 1
- 7 -
ATTACHING THE TOY BAR AND TOYS
Slot the clips on the ends of
the toy arch over the arms of
the swing, as shown in the
diagram.
Wrap the fabric collar on the
end of the toys over the play
arch. Fasten the velcro pads on
the ends of the collars together.
USING THE SWING LOCK
The seat of the swing can be
locked into position.
Under the front of the seat
there is a rotatable locking
arm. To lock the seat in place
rotate the lock through 180º.
Push the end of the locking
arm over the metal tube at the
front of the swing.
To undo the lock, simply pull
upwards and rotate back under
the seat.
- 8 -
OPERATING THE SWING
On the right side of the frame
there is the control panel
for the swinging and sound
functions.
1 Swing power on/off
Press this button to activate
and switch off the swing
function.
2 Timer
This regulates the length of
time the swing will run for
either 5, 10 or 15 minutes then
it will automatically turn itself
off.
3 Motion setting
This sets the amount of power
used to move the swing
dependent on the weight of
your child.
Pressing 0 will stop the swing
without interrupting the timer.
You may need to gently push
the swing to get it started
4 Music
Press the middle button to
activate the music.
Pressing the button again and
you can scroll through the
tunes available.
Press the’+’ button to increase
the volume of the music.
Press the ‘-’ button to decrease
the volume of the music.
Press and hold the middle
button in and the music
function will switch off.
0
0
1
2
3
4
5
3 6
9
Motion settings
Weight in kilograms
Peak performance
Optimum performance
- 9 -
FOLDING THE SWING
Adjust the backrest into the
upright position 1.
Push the footrest upwards 2.
Grip the bottom tube and
swing around until it is against
the uprights sections of the
frame 3.
The frame can now be stored
away from young children.
- 10 -
USING THE AUDIO SYSTEM
The Dream Swing is equipped
with a jack port on the plastic
housing on the rear right leg.
This enables you to plug in any
audio device that has a 3mm
headphone outlet built in to it.
To use the system
Insert one of the jack plugs into
the outlet in the rear housing of
the swing.
Insert the other jack plug into
the outlet of the audio system.
Important: Check that volume
on the audio unit is turned
down as this will control the
volume of the sound emitted
by the Dream Swing (not the
volume control on the swing).
- 11 -
REMOVING THE COVER
Undo the two straps on the
underside of the swing 1.
Push the clips of the studs
behind the plastic discs on the
bottom of the swings seat 2.
Pull the cover off the swings
frame 3.
Wash the cover following the
instructions on the wash care
label on the cover.
Re-fit the cover by reversing
the process used to remove it.
- 12 -
INSTRUCTIONS FOR SAFE USE
• Warning: A child’s safety is your responsibility
• Warning: Never leave the child unattended.
• Warning: Never carry the swing with a child in it.
• Do not use the reclined cradle once your child can sit unaided.
• This reclined cradle is not intended for prolonged periods of sleeping.
• It is dangerous to use this reclined cradle on an elevated surface, e.g. a table.
• Always use the restraint system.
• Never use the toy bar to carry the reclined cradle.
• This reclined cradle is intended for children from birth to a maximum weight
of 9kg.
• This reclined cradle does not replace a cot or a bed. Should your child need to
sleep, then it should be placed in a suitable cot or bed.
• Do not use the reclined cradle if any components are broken, torn or missing.
• Do not use accessories or replacement parts other than those approved by
the manufacturer.
• Prolonged and direct exposure to bright sunlight can change the fabrics colours.
Try to limit if possible.
• Assemble and adjust the Dream Swing with care.
• The reclined cradle can be wiped clean with a damp cloth. Never use bleach or
harsh abrasives.
Battery Safety Information:
• Only an adult should access the battery compartments. Ensure that the battery
compartments are securely closed before the product is used.
• Use only the batteries recommended and insert them correctly.
• Do not mix old and new batteries. Do not mix batteries of different types.
• Do not attempt to recharge non-rechargeable batteries.
• Rechargeable batteries must be removed from the product before being
recharged.
• Recharging batteries must be carried out by an adult.
• Remove exhausted batteries and dispose of them at an official waste disposal
site. Do not burn or place in household waste.
This symbol on the product or documentation denotes that the item may not be disposed of as normal household waste.
This item must be handed over at an applicable collection point for the recycling of electrical and electronic equipment.
For more information please contact your local waste disposal service or the shop that you purchased the item from.
/
