Hubbell Stainless Steel Banding Operating instructions

Brand: Hubbell

Model: Stainless Steel Banding

Type: Operating instructions

Part No. PSP2160528

Installation Instructions for

STAINLESS STEEL BANDING ASSEMBLY

NOTE: Hubbell has a policy of continuous product improvement.

We reserve the right to change design and speciﬁcations without notice.

©

Copyright 2013 Hubbell Incorporated Printed in USA

1. Measure the circumference of the pole where the band

is to be installed.

2. Cut the band to a length of 8” to 12” beyond the

measured circumference of the pole plus whatever

is necessary for additional hardware that will be

installed.

3. Measure 4” to 6” from the end and mark the band.

Bend the band at this mark, then strike band to create

a sharp radius.

Continued on the next page > > > > > >

®

Unassembled band with buckle

Buckle Retainer: End View

Carriage Bolt

Washer

Nut

Fixed Retainer Sliding Retainer

¾" Slot

1 ¼" Slot

Assembled band with buckle

Part No. PSP2160528

Page 2 of 2

4. Slide the band through the ﬁxed retainer in the

appropriate size slot and fold the band under retainer

where marked.

5. Repeat steps 3 and 4 for the sliding retainer.

6. Bend the band to a 90° angle at the end of each

retainer.

7. Place banded assembly around pole at desired location

and install the carriage bolt through the two

aluminum retainers.

8. Install nut and washer on carriage bolt.

9. Tighten until assembly is secure and all slack has been

taken up.

10. Installation Complete

These instructions do not claim to cover all details or variations in equipment, nor to provide for all possible conditions to be met concerning

installation, operation, or maintenance of this equipment. If further information is desired or if particular problems are encountered which

are not sufﬁciently covered in this guide, contact Hubbell Power Systems.

1
2

Hubbell Stainless Steel Banding Operating instructions

Brand: Hubbell

Model: Stainless Steel Banding

Type: Operating instructions

Related papers

Other documents