2. horntools
  3. HQF50050

horntools HQF50050 Owner's manual

  • Hello! I've reviewed the document for the QUICK FIST clamp and am ready to answer your questions. This document includes instructions on how to install the clamp using the provided template, secure an object with the strap and also provides information on safe working load of 50lbs and 15lbs in crew quarters.
  • What is the safe working load of the QUICK FIST clamp?
    What is the safe working load in crew quarters?
    How do I mount the QUICK FIST clamp?
    Can the strap be mounted in any direction?
    How do I clamp an item using the QUICK FIST?
Safe Working load of each NOZZLE QUICK FIST:
Safe Working Load: Safe Working Load in
1 Clamp Crew Quarters (NFPA 1901):
Screw or bolt: 50lbs (23 kilos) 1 Clamp
Screw or bolt: 15lbs (7 kilos)
Installation Instructions:
1. The two protrusions on the base will keep the clamp from
turning while in use. Using the template below, drill 3 X
1/4" (6mm) holes. The outer two holes need be about
1/8" (3mm) deep. Use a 1/4" bolt or screw and a wash-
er to mount the QUICK FIST clamp.
2. The QUICK FIST can be mounted with the strap facing in
any direction.
3. To clamp: Put the Nozzle between the jaws and push the
strap to reach the desired tightness.
Item #50050
Made in USA
End of the Road, Inc
2212 Dortch Ave.
Nashville, TN 37210, USA
www.endroad.com
U.S. and world wide patents pending
UK patent 2403262
TemplaTe
Safe Working load of each NOZZLE QUICK FIST:
Safe Working Load: Safe Working Load in
1 Clamp Crew Quarters (NFPA 1901):
Screw or bolt: 50lbs (23 kilos) 1 Clamp
Screw or bolt: 15lbs (7 kilos)
Installation Instructions:
1. The two protrusions on the base will keep the clamp from
turning while in use. Using the template below, drill 3 X
1/4" (6mm) holes. The outer two holes need be about
1/8" (3mm) deep. Use a 1/4" bolt or screw and a wash-
er to mount the QUICK FIST clamp.
2. The QUICK FIST can be mounted with the strap facing in
any direction.
3. To clamp: Put the Nozzle between the jaws and push the
strap to reach the desired tightness.
Item #50050
Made in USA
End of the Road, Inc
2212 Dortch Ave.
Nashville, TN 37210, USA
www.endroad.com
U.S. and world wide patents pending
UK patent 2403262
TemplaTe
/