6mm 3x2 Shops Foyer
B06-MW-100
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Foyer (B06-MW-100)
Start by removing the short sides from the sprue
along with the two bracers.
Glue the bracers bar to the back of the short side,
positioned using the lugs provided.
Attach the long sides, so that both the side lugs
and bracer lugs fit into the holes provided.
This will give you a hollow box shape.
Attach the columns and balconies to the long
sides as shown above.
Then attach the columns and balconies to the short
sides.
6mm 3x2 Shops Middle
B06-MW-150
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Mid-Section (B06-MW-150)
Remove the walls, two bracer bars and four
supports from the sprue. Glue the bracers to the
back of the two short walls as shown in the
example above. Also attach the support to the
bottom edge on the back of each wall. Leave to
dry.
Once the bracers are dry, apply a little glue to the side
lugs and glue the shorter walls in place. You should
now have a hollow square structure. Leave it to dry.
Note: In the image above, the structure is upside
down, so the supports are seen at the top of the
picture.
Glue the balconies into position on the long
walls…
…and then on the short walls.
6mm 3x2 Shops Roof
B06-MW-200
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Roof Section (B06-MW-200)
Remove the four walls, roof and supports from
the sprue.
Glue the supports into position below the
windows on the back of the walls.
Apply glue to the edges of the roof and attach the
walls to it using the lugs provided (etched detail
outwards).
Glue the balconies into position below the
windows on the long sides…
..then on the short sides.
-
1
-
2
-
3
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
BLOTZ B28-SFW-007 Assembly Instructions
-
BLOTZ B10-ME-003 Assembly Instructions
-
BLOTZ B28-DA-103 Assembly Instructions
-
BLOTZ B06-CS-009 Assembly Instructions
-
BLOTZ B06-MW-103 Assembly Instructions
-
BLOTZ B06-MW-005 Assembly Instructions
-
BLOTZ B28-ME-010 Assembly Instructions
-
BLOTZ B00-ACC-400 Assembly Instructions
-
BLOTZ B06-MW-002 Assembly Instructions
-
BLOTZ B15-PS-004 Quick start guide
