2. OTC
  3. 7771A

OTC 7771A Operating instructions

  • Hello! I've reviewed the instructions for the OTC Power Steering Pump Pulley Installer models 7771A and 211-185. This document provides guidance on how to safely and correctly install Ford power steering pump pulleys using the provided tooling and outlines important steps, such as hand-tightening the forcing screw and regularly lubricating it. I'm ready to assist you with any questions you may have regarding these instructions or the product's operation.
  • What is the purpose of this tool?
    What should I do before using the tool?
    How should the forcing screw be tightened?
    What type of lubrication should be used?
    What voids the warranty?
Form No. 550622
Instructions for: 7771A
211-185
655 Eisenhower Drive
Owatonna, MN 55060 USA
Phone: (507) 455-7000
Tech. Serv.: (800) 533-6127
Fax: (800) 955-8329
Order Entry: (800) 533-6127
Fax: (800) 283-8665
International Sales: (507) 455-7223
Fax: (507) 455-7063
Ford Power Steering Pump Pulley Installer
1. Assemble drive nut and pulley onto forcing screw as shown.
2. Thread forcing screw into pump shaft until forcing screw
taper touches against pump shaft.
3. Verifypulleyisushwithpumpshaft.
4. Hold forcing screw in place, and turn drive nut against pulley
until pulley is pressed onto pump shaft to correct depth.
CAUTION: To prevent equipment damage,
• Do NOT force or over tighten forcing screw into pump
shaft. Hand tighten only.
• Regularly lubricate forcing screw using No. 280934
pressure lubricant or equivalent.
USE OF AN AIR TOOL WITH THIS INSTALLER WILL VOID
WARRANTY.
CAUTION: To prevent personal injury, wear eye pro-
tection that meets ANSI Z87.1 and OSHA standards.
Drive
Nut
Forcing
Screw
Pump Shaft
Taper
Pulley
Form No. 550622
Instructions for: 7771A
211-185
655 Eisenhower Drive
Owatonna, MN 55060 USA
Phone: (507) 455-7000
Tech. Serv.: (800) 533-6127
Fax: (800) 955-8329
Order Entry: (800) 533-6127
Fax: (800) 283-8665
International Sales: (507) 455-7223
Fax: (507) 455-7063
© Bosch Automotive Service Solutions LLC
Rev. B, June 16, 2014
Ford Power Steering Pump Pulley Installer
1. Assemble drive nut and pulley onto forcing screw as shown.
2. Thread forcing screw into pump shaft until forcing screw
taper touches against pump shaft.
3. Verifypulleyisushwithpumpshaft.
4. Hold forcing screw in place, and turn drive nut against pulley
until pulley is pressed onto pump shaft to correct depth.
CAUTION: To prevent equipment damage,
• Do NOT force or over tighten forcing screw into pump
shaft. Hand tighten only.
• Regularly lubricate forcing screw using No. 280934
pressure lubricant or equivalent.
USE OF AN AIR TOOL WITH THIS INSTALLER WILL VOID
WARRANTY.
CAUTION: To prevent personal injury, wear eye pro-
tection that meets ANSI Z87.1 and OSHA standards.
Drive
Nut
Forcing
Screw
Pump Shaft
Taper
Pulley
© Bosch Automotive Service Solutions LLC
Rev. B, June 16, 2014
/