dji Aeroscope User guide

DJI AeroScope Offline Update Guide

The firmware version of DJI AeroScope Stationary Unit and DJI AeroScope Mobile can be

updated using a special version of DJI Assistant 2 for AeroScope. Follow the instructions below

to update the firmware using DJI Assistant 2.

1. Go to the official DJI Download page of AeroScope and download the latest offline

firmware package on your computer.

Link: https://www.dji.com/downloads/products/aeroscope

2. Go to the link below and download the DJI Assistant 2 for AeroScope software package on

your computer.

Link: https://pan-sec.djicorp.com/s/Yc52tacxxXBZQaw

The official version of DJI Assistant 2 for AeroScope on DJI website does not support the

offline firmware update.

3. Install and run DJI Assistant 2 for AeroScope on your computer.

4. Connect your computer and the AeroScope unit using an Ethernet cable. The

corresponding device icon of the AeroScope unit will be displayed when connected. If the

assistant software cannot recognize the AeroScope unit, restart your computer, disable the

wireless network, and close the firewall software before running the assistant software

again.

5. Select the device icon and click on Offline Upgrade. Select the downloaded offline firmware

package in step one, and click Start Upgrade to update.

6. When the firmware is updated successfully a prompt will appear, confirming the update is

completed. If the update fails, restart DJI Assistant 2 for AeroScope and try again.