15
[SR04300(ALL)02/94]
If the driver does not fasten the lap belt before
the ignition key is turned to ON, the chime will
sound for four (4) to eight (8) seconds. The
safety belt warning indicator lamp in the
instrument cluster will also illuminate for one to
two minutes. In the unlikely event the shoulder
belt should stall before it reaches the B-pillar, the
indicator light will flash continuously until the
shoulder belt is in its locked position at the
B-pillar. If the indicator lamp remains
illuminated for more than one minute, check to
be sure that both shoulder belts are latched to
the emergency release buckle. If the indicator
lamp remains illuminated with both front seat
shoulder belts latched to the emergency release
buckles, refer to the section titled What To Do If
Your Shoulder Belt Does Not Engage Properly
before driving the vehicle.
[SR04400(ALL)04/93]
Use the shoulder belt on the outside shoulder
only. Never wear the shoulder belt under the
arm. Never swing it around your neck over the
inside shoulder. Never use a single belt for more
than one person. Failure to follow these
precautions could increase the risk and/or
severity of injury in a collision.
[SR04500(ALL)02/95]
When the ignition is in any position and the
door is opened, the shoulder belt will move
forward to the A-pillar. This will allow ample
room for the driver or passenger to exit from
the vehicle. DO NOT use the belt as an assist
handle when entering or exiting the vehicle. The
door should not be opened while the vehicle is
in motion.
[SR04550(ALL)09/95]
NOTE: Be sure to read and understand
Important Safety Belt Information at
the beginning of this chapter.
File:03ctsre.ex
Update:Tue Sep 19 15:05:35 1995