2. Notifier
  3. BG-10 Pull Station Locking

Notifier BG-10 Pull Station Locking Operating instructions

  • I have reviewed the installation instructions for the BG-10 Locking Safety Clip. This document outlines how to install the clip to increase the tamper resistance of the BG-10 series pull station. I can help you with any questions you have regarding the installation process or the features of the clip.
  • What is the purpose of the Locking Safety Clip?
    Can an activated pull station be forced back into the inactivated position without unlocking?
    How is the Locking Safety Clip installed?
BG-10
Locking Safety Clip
Installation
Document 51329 Rev. A 3/22/00 ECN: 00 - 114
General Information
The Locking Safety Clip is an enhancement to the operation of the BG-10 Series Pull Station. Its purpose is
to increase the "tamper" resistance of the pull station. The safety clip does not allow an activated pull station
to be forced back into the inactivated position, without first unlocking and opening the pull station door.
Safety Clip Installation
1. Open the BG-10 pull station cover-door using the key or appropriate hex wrench. The open door will rest
in a perpendicular position to the attached mounted back-plate.
2. Holding the door as shown in Figure 1, snap the locking clip into position over the end of the activating
handle. Figure 2 shows the locking clip installed in the correct position.
3. Close and lock the BG-10 pull station cover-door.
Figure 2Figure 1
www.PDF-Zoo.com
firealarmresources.com
/