FMI CF26PT Operating instructions

Type
Operating instructions

This manual is also suitable for

IMPORTANT: Relocation of thermobulb should be done before unit is installed.
1. Gently pull thermobulb from clip.
2. Route thermobulb and wire through oval hole in base as shown in figure below.
3. Remove paper from adhesive on new thermobulb clip and place clip on floor pan next to control knob as shown in figure below.
4. Slide thermobulb into new clip.
RELOCATING THERMOBULB
FOR FIREPLACE MODELS
CF26NT/PT
2701 Industrial Drive
P.O. Box 90004
Bowling Green, KY 42102-9004
www.desatech.com
111866-01
Rev. A
06/03
NOT A UPC
111866 01
L
O
P
I
L
O
T
O
F
F
HI
L
O
P
I
L
O
T
OFF
HI
Original
Thermobulb
Location
Adhesive
Thermobulb
Clip
Thermobulb
Routing Hole
in Base
  • Page 1 1

FMI CF26PT Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI