TEL/DVR/SAT/DSL
IN
OUT OUT
DATA
PORT
CATV/MODEM
SATELLITE
ANTENNA
IN
IN
IN
OUT OUT
OUT
OUT
ETHERNET
IN OUT
DC TRIGGER
IN OUT
INPUT 120V
47-63 Hz 12A
SYSTEM GROUND
CIRCUIT
BREAKER
PUSH
TO
RESET
BUILDING
WIRING FAULT
120V 12A 47-63 Hz
900 W 1440VA
US LISTED
42C2
CD DVD DVR
CATV/SAT
MONITOR AUX
TV VCR
DELAYED
DELAYED2
SUBWOOFER
AMPLIFIER
TUNER/AUX
PREAMP/RVCR
ANALOG FILTER
HIGH CURRENT FILTER
VIDEO FILTER
DIGITAL FILTER
1
NYCE
TEL/DVR/SAT/DSL
IN
OUT OUT
DATA
PORT
CATV/MODEM
SATELLITE
ANTENNA
IN
IN
IN
OUT OUT
OUT
OUT
ETHERNET
IN OUT
DC TRIGGER
IN OUT
INPUT 120V
47-63 Hz 12A
SYSTEM GROUND
CIRCUIT
BREAKER
PUSH
TO
RESET
BUILDING
WIRING FAULT
120V 12A 47-63 Hz
900 W 1440VA
US LISTED
42C2
CD DVD DVR
CATV/SAT
MONITOR AUX
TV VCR
DELAYED
DELAYED 2
SUBWOOFER
AMPLIFIER
TUNER/AUX
PREAMP/RVCR
ANALOG FILTER
HIGH CURRENT FILTER
VIDEO FILTER
DIGITAL FILTER
1
NYCE
Item Specification
Nominal Voltage 48 Vdc
Battery Quantity/Type Eight 12-Volt, 9-Amp-Hour, Sealed Lead -Acid, Maintenance-
Free Batteries
Battery Service Not User-Serviceable
Battery Life 2-5 Years (Depending on use, environment, and temperature)
Battery Runtime: 1 SBATT + S15 battteries:
Full load: 32 minutes. Half load: 81 minutes
2 SBATTs + S15 batteries:
Full load: 62 minutes. Half load: 159 minutes
Note: Actual runtimes are determined by load, battery charge
level, battery health and quantity of batteries installed.
Additional runtime can be achieved by adding a second SBATT
unit to your system.
Unit Dimensions 17 x 3.5 x 18.55 in. (43.2 x 8.9 x 47.1 cm)
Unit Weight 55 lbs.
Warranty The standard warranty is two (2) years from the date of purchase.
APC’s standard procedure is to replace the original unit with a
factory reconditioned unit. Customers who must have the
original unit back due to the assignment of asset tags and set
depreciation schedules must declare such a need at first contact
with an APC Technical Support representative. APC will ship
the replacement unit once the defective unit has been received by
the repair department, or cross-ship upon the receipt of a valid
credit card number. The customer pays for shipping the unit to
APC. APC pays ground freight transportation costs to ship the
replacement unit to the customer.
990-1932 Copyright 2005 American Power Conversion Corporation.
APC and APC/AV are registered trademarks of American Power Conversion.
All other trademarks are the property of their respective owers.
S-Type Extended
Battery Pack
Installation Manual
S15 Power Conditioner with Battery Backup S15 Power Conditioner with Battery Backup
Extended Battery
Connecting Cable
Connecting Cable Connecting Cable
Specifications S15 with 1 Extended Battery Pack S15 with 2 Extended Battery Packs
Pack
Extended Battery
Pack
Extended Battery
Pack
Grounding Cable Grounding Cable
Grounding Cable
Ground Connection
Power Cable
Retaining Screw
(Installs above cable
on Battery Pack;
Installs below Cable
on S15)
Thank you for purchasing APC AV's S-Type Extended Battery Pack. Designed exclusively for the APC AV S15 Power Conditioner with Battery Backup, up to two SBATT Extended Battery Packs can be added to increase
available battery runtime by 200%. Please register your product by filling out and mailing the enclosed Warranty Registration Card, or by registering online at www.apcav.com.
Notes on Battery Replacement: Batteries contained within the SBATT are not user serviceable or replaceable. Contact your dealer, distributor, or APC to purchase another SBATT Extended Battery Pack.
The S15 performs an automatic Self-Test every two weeks by default. If the test fails, a Replace Battery message will appear on the S15's front display. To determine if it is the internal S15 battery pack or the external
SBATT Extended Battery Pack that needs replacing, disconnect the SBATT and initiate a new Self-Test. If the test passes, the SBATT likely needs to be replaced. If in warranty, contact APC Technical Support (see
below). If the test fails again, then the internal battery pack likely needs to be replaced. To initiate a Self-Test manually, press the Setup button on the front display until you reach the "Initate Self-Test" screen. Use
the "up" or "down" arrows to initiate the test."
SAFETY PRECAUTIONS
Please ensure you have read and understand all of the safety information located at the front of the S15 User’s Manual. If you have any questions about the safety information, or are concerned that your home may not be properly
wired for this equipment, please contact APC Technical Support or a qualified and licensed electrician.
Also note, this unit weighs 55 pounds. Two-person lift is required to install this device. Failure to comply may result in personal injury and/or equipment damage. Further, ensure the unit is place on a surface able to hold more than
55 pounds. If rack-mounting the unit, refer to the instructions provided with the mounting brackets and slide rails.
Do not install this device during a lightning storm. Do not dispose of this device by placing it in a fire. Please contact APC for information on the proper recycling and disposal of lead-acid batteries.
Internet Address: www.apcav.com
Email Support: support.apcc.com
Toll free: (888) 88-APCAV
Address: American Power Conversion
132 Fairgrounds Road
West Kingston, RI 02892 USA
Contact Information
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
American Power Conversion S15BLK User manual
-
Rotel RLC-1080 User manual
-
Sony ES27 User manual
-
-
-
Motorola C200 User manual
-
Crestron electronic CEN-UPS1250 User manual
-
-
Sanyo DC-007C User manual
-
ParaBody 838 User manual
