Encore ENLTV User manual

Personal Video Recorder

ENLTV / ENLTV-FM

(PCI TV Capture Card)

ENLTV Series

User’s Guide

Version 2.2

ENLTV User’s Guide -

User’s Notice

No part of this manual, including the products and software described in it, may be

reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in

any form or by any means, except documentation kept by the purchaser for backup purposes,

without the express written permission of us.

WE PROVIDES THIS MANUAL “AS IS” WITHOUT WARRANTY OF ANY KIND,

EITHER EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED

WARRANTIES OR CONDITIONS OF MERCHANTABILITY OR FITNESS FOR A

PARTICULAR PURPOSE. IN NO EVENT SHALL US, ITS DIRECTORS, OFFICERS,

EMPLOYEES OR AGENTS BE LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL, OR

CONSEQUENTIAL DAMAGES (INCLUDING DAMAGES FOR LOSS OF PROFITS, LOSS

OF BUSINESS, LOSS OF USE OR DATA, INTERRUPTION OF BUSINESS), EVEN IF WE

HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES ARISING FROM ANY

DEFECT OR ERROR IN THIS MANUAL OR PRODUCT.

Product warranty or service will not be extended if: (1) the product is repaired, modified or

altered, unless such repair, modification of alteration is authorized in writing by us; or (2) the serial

number of the product is defaced or missing.

Products and corporate names appearing in this manual may or may not be registered

trademarks or copyrights of their respective companies, and are used only for identification or

explanation and to the owners’ benefit, without intent infringe.

z Windows, MS-DOS, and DirectX are registered trademarks of Microsoft Corporation.

z Adobe and Acrobat are registered trademarks of Adobe Systems Incorporated.

The product name and revision number are both printed on the product itself. Manual revisions are

released for each product design represented by the digit before and after the period of the manual

revision number. Manual updates are represented by the third digit in the manual revision number.

SPECIFICATIONS AND INFORMATION CONTAINED IN THIS MANUAL ARE

FURNISHED FOR INFORMATION USE ONLY, AND ARE SUBJECT TO CHANGE AT ANY

TIME WITHOUT NOTICE, AND SHOULD NOT BE CONSTRUED AS A COMMITMENT BY

US. WE ASSUME NO RESPONSIBILITY OR LIABILITY FOR ANY ERRORS OR

INACCURACIES THAT MAY APPEAR IN THIS MANUAL, INCLUDING THE PRODUCTS

AND SOFTWARE DESCRIBED IN IT.

2

ENLTV User’s Guide -

Contents:

Chapter 1: Introduction...................................................................................................................... 4

1.1 - Package Contents............................................................................................................... 4

1.2 - System Requirements........................................................................................................ 4

Chapter 2: Getting Started ................................................................................................................. 5

2.1 - ENLTV / ENLTV-FM Hardware Installation.................................................................... 5

2.2 - Device Driver Installation ................................................................................................. 6

2.3 - Install the DirectX® ........................................................................................................ 14

2.4 - Install the ENLTV Utility software. ................................................................................ 15

Chapter 3: Launch the ENLTV Program ......................................................................................... 20

3.1 - Running the ENLTV for the first time............................................................................. 20

3.2 - Watch TV programs or movies from DVD/VCR/Camcorder ......................................... 22

3.3 - Record Video................................................................................................................... 23

3.4 - Snapshot Image................................................................................................................ 24

3.5 - Playback Video................................................................................................................ 24

3.6 - Browse Images ................................................................................................................ 26

3.7 – Time-Shifting.................................................................................................................. 27

3.8 - Using and setting up the FM Radio................................................................................. 29

Chapter 4: Using the Remote Control.............................................................................................. 30

Chapter 5: Frequently Asked Questions .......................................................................................... 31

Chapter 6: Technical Support........................................................................................................... 34

3

ENLTV User’s Guide -

Chapter 1: Introduction

1.1 - Package Contents

The following items are included in the ENLTV / ENLTV-FM package.

z CD Setup Disc (includes Software Driver and Utility Software)

z ENLTV or ENLTV-FM PCI Card

z Video Cable

z Audio Cable

z Remote Controller

z FM Antenna (ENLTV-FM only)

z User’s Guide

1.2 - System Requirements

z Intel® Pentium® 4 1.7GHz CPU or above

z Minimum 256 MB memory

z Minimum 1GB hard disk space available

z 1024x768 graphic card, DirectX

®

9.0c or above compatible graphic card or higher

z One free PCI slot

z PCI 2.1 or 2.2 compliant interface

z Microsoft Windows® XP/ Windows Vista™

z CD-ROM drive

4

ENLTV User’s Guide -

Chapter 2: Getting Started

2.1 - ENLTV / ENLTV-FM Hardware Installation

Install the ENLTV / ENLTV-FM PCI Card to the

computer’s available PCI slot according to your

computers manual and new hardware installation

procedures. Make sure that the computer’s power

cord is unplugged before inserting the ENLTV /

ENLTV-FM card to the PCI slot. ENLTV /

ENLTV-FM supports PCI bus 2.1 and above.

Refer to the device connection diagram below for port connections:

Caution:

Take an extra care handling the Remote sensor cable, do not insert or remove the sensor

cable while the computer is powered-on. Otherwise, it can cause the ENLTV / ENLTV-FM

to malfunction.

5

ENLTV User’s Guide -

2.2 - Device Driver Installation

1. Placed the CD software that comes with the ENLTV / ENLTV-FM in the CD-ROM drive.

(Assuming that the ENLTV / ENLTV-FM PCI TV Tuner card is properly installed to the

computer’s PCI slot), then follow the on-screen installation guide below.

Device driver installation for Windows® XP Home/Professional Edition/x64 Edition

1. When the computer is powered-on for the

very first time during the setup, a

message “Found New Hardware Wizard”

dialogue box will appear on the screen.

Click “Cancel” button to close “Found New

Hardware Wizard” window.

1. Insert the installation CD into the

CD-ROM drive. The setup screen will

automatically appear.

1. Select the language

2. Click the “Setup Driver” button.

6

ENLTV User’s Guide -

3. Click “Next” on driver setup welcome

window to continue.

4. Make sure the “Complete” radio button is

selected then click “Next”

5. Click “Install” to begin install driver.

7

ENLTV User’s Guide -

6. Click “Next” button.

7. Click “Continue Anyway” to continue the

installation.

8. Click ”Continue Anyway” button

8

ENLTV User’s Guide -

9. Click “Finish” button

10. Click “Finish” to reboot PC.

11. To make sure the driver is properly

installed and started, open the “Device

Manager”. Please double-click the

“Sound, video and game controller”.

9

ENLTV User’s Guide -

Device driver installation for Windows Vista™

1. After ENLTV / ENLTV-FM hardware has

been installed, the next time when the

computer is powered-on, a message

“Found New Hardware” dialogue box will

appear on the screen. Click “Cancel”

button to close “Found New Hardware”

window.

2. Insert the installation CD into the

CD-ROM drive. The setup screen will

automatically appear.

3. Select the language

4. Click the “Setup Driver” button.

10

ENLTV User’s Guide -

5. Click “Next” on driver setup welcome

window to continue.

6. Make sure the “Complete” radio button is

selected then click “Next”

7. Click “Install” button

11

ENLTV User’s Guide -

8. Click “Next” button

9. Click “Finish” button

10. Click “Finish” button.

12

ENLTV User’s Guide -

11. To make sure the driver is properly

installed and started, open the “Device

Manager”. Please double-click the

“Sound, video and game controller”.

13

ENLTV User’s Guide -

2.3 - Install the DirectX®

Microsoft DirectX® allows 3D hardware acceleration support in Windows® 98, 2000,

Windows® XP/64 bit and Windows Vista™ 32bit/64bit. For software MPEG support in

Windows 98, you must first install Microsoft DirectX®, and then an MPEG compliant video

player. Follow the installation steps below to install MS DirectX®.

1. Insert the installation CD into the

CD-ROM drive. The setup screen will

automatically appear.

2. Select the language

3. Click the “DirectX” button.

4. Click “Accept the agreement” radio button

then click “Next”

14

ENLTV User’s Guide -

5. Click “Next” to confirm the installation of

DirectX

6. Click “Finish”

NOTE:

The computer will automatically restart.

Please save any unsaved files and close all

programs before hitting the “Finish” button.

2.4 - Install the ENLTV Utility software.

1. Install TV application on Windows XP Home/Professional Edition

1. Insert the installation CD into the

CD-ROM drive. The setup screen should

automatically appear.

2. Click the “Setup Utility”

3. Click “Next” button to start the ENLTV

Installation

15

ENLTV User’s Guide -

4. Please read the License Agreement and

click “Yes” button

5. Make sure the “Typical” radio button is

selected then click “Next”

6. Click “Next” button to accept the default

location or choose a different folder

Note:

We recommend not to change the default

location

7. Click “Next” button.

16

ENLTV User’s Guide -

8. Click “Finish” button.

NOTE:

We recommend restarting your computer

right after the Installation Wizard.

2. Install TV application on Windows Vista™ 32/64bit

1. Insert the installation CD into the

CD-ROM drive. The setup screen will

automatically appear.

2. Select the language

3. Click “Setup Utility”

4. Click “Next” button to start the ENLTV

Installation

17

ENLTV User’s Guide -

5. Please read the License Agreement and

click “Yes” button

6. Make sure the “Typical” radio button is

selected then click “Next”

7. Click “Next” button to accept the default

location or choose a different folder

Note:

We recommend not to change the default

location

18

ENLTV User’s Guide -

8. Click “Next”

9. Click “Finish” to restart your computer.

NOTE:

We recommend restarting your computer

right after the Installation Wizard.

19

ENLTV User’s Guide -

Chapter 3: Launch the ENLTV Program

3.1 - Running the ENLTV for the first time

Click “Start”, move your mouse to “Programs\ENLTV\ENLTV” then click ENLTV

NOTE:

When the ENLTV Program is first started, it will prompt you to configure the Device

Setting.

20

Page is loading ...

Encore ENLTV User manual

This manual is also suitable for

Encore ENLTV User manual

Related papers

Other documents