CAR CREEPER ASSEMBLY
Car creeper parts are contained within a polythene bag, and include a hex.
wrench for tightening the securing screws for the various components.
1. Place the two halves of the creeper together, with the open ends of the rails
‘B’, abutting.
2. Position the clamp plate ‘A’ over the ends of the rails and insert the collars
through the rails and into the clamp plate.
3. Secure by screwing in the screws from the opposite side of the rail and tighten
securely using a cross head screwdriver at the screwhead and hex. wrench at
the collar head.
4. Push the threaded shaft of the Caster through the hole in the frame, from the
underside, and screw on the collar. Tighten using the Hex. wrench provided.
When all four are assembled, your creeper is ready for use.
For Spare Parts and Service, Tel: 020 8988 7400
CLARKE International, Hemnall Street, Epping, Essex, CM16 4LG
Inside
SPECIFICATIONS
Trolley Jack
MAX. Load ............................... 2 Tonnes
MIN Saddle Height .................. 135mm
MAX. Height ............................. 340mm
Axle Stands
MAX. Load ........................ 2 Tonnes
Creeper
Dims (LxW) ........................ 920x380mm
MAX. Load ........................ 100kg
Collar
Screw
Collar