www.cap-homey.com User Manual
CAP-TECH INTERNATIONAL CO.,LTD.
DOOR/WINDOW DETECTOR
Introduction
In general, there are two ways for criminals to break into a flat: one is to steal to the master
key, and then open the door; the second is use tools to open the door. No matter what ways the
criminals are using, he must open the door/window of the house. Once a thief pushes the door, the
door and the door frame will displacement, the door sensor and magnet will produce a shift, and
Door/Window Detector will send alarm signals to remind staff to take safety measures.
The Door/Window Detector is a device with built-in EnOcean module. This device can be
included and operated in any EnOcean network with other EnOcean certified devices from any
other manufactures. It is a passive wireless sensor. With the magnet, the sensor detects "open" or
"close" status (door or window).
CT-SMEF2001-SNB
Door/Window Detector
www.cap-homey.com User Manual
CAP-TECH INTERNATIONAL CO.,LTD.
Technical Information
Compatible with any EnOcean network controller
Without external power supply
With the magnet, the sensor detects "open" or "close" status (door or window).
Easy to install
Long service life
Specifications
Radio protocol: EnOcean 868MHz(can use different frequency module according to different
areas)
Data rate/Modulation type: 125kbps/FSK
Power supply: Wireless passive, Solar energy (or use CR1216 battery)
Initial operation time in darkness @ 25°C: typ. 4 day if energy storage fully charged
Operation start up time with empty energy store: typ. 2.5 min @ 400 lux / 25°C incandescent
or fluorescent light
Temperature range：-20～60℃
Transmission distance: outdoor 100 m, indoor 30 m
Dimension：83.5mm×26mm×19mm
Operation
Including of EnOcean network
1) Choose "Enocean" to enter the Network Inclusion mode on the APP, and input the Apparatus
ID, then click "Save".
www.cap-homey.com User Manual
CAP-TECH INTERNATIONAL CO.,LTD.
2) Press the pairing button on the back in 8 seconds (open the rear lid).
3) When prompt a message “Request Access Success”, please go to the device list interface, and
refresh the device list, the device will be displayed.
Installation Instructions
It’s recommended to install the Door/Window Detector in dry interior locations.
Installation Tips
The Door/Window Detector installation is very convenient. Even people who do not understand
the knowledge of electrical equipment can be very convenient to install. You can place it at any
door / window. Just need to stick the back of the Door/Window Detector with double-sided adhe-
Pairing Button
www.cap-homey.com User Manual
CAP-TECH INTERNATIONAL CO.,LTD.
sive, and stick it to the door or window. If you want to replace the installation position in the fu-
ture, you can also take off the detector, and stick the device once more time.
DOOR/WINDOW DETECTOR INSTALLATION
Decide which doors/windows to be protected by Door/Window Detectors, (usually the front and
back doors as a minimum will have Door/Window Detectors fitted). Additional detectors may also
be fitted where required to other vulnerable doors or windows (e.g. garage, patio/conservatory
doors etc.).
1. Ensure that the system properly powered
The Door/Window Detector is a passive wireless sensor, supplied by solar energy (or use
CR1216 battery).
2. Using the adhesive tape to fit detector on the door or window.
3. Fit the magnet to the moving part of the door/window opposite the detector using the adhe-
sive tape.
4. Ensure that the parallel gap between the magnet and detector is less than 15mm and that the
matching line on the magnet is pointing towards and aligned with the line on the detector.
5. After proper installation and test, put the battery cover back to the detector and the detector
enters the normal.
Safety Notice
During installation, protect the device from any physical damage by dropping or bumping. If
happened, please contact the supplier for maintenance.
Keep the device away from acid-base and other corrosive solids, liquids, gases, to avoid
damage.
Avoid overexertion during operation, to protect device from mechanical damage.
Pay attention to the using range.
Read all instructions and documentation and save for future reference.
-
1
-
2
-
3
-
4
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
GP CR1216 User manual
-
ETC echoflex MOS-MT Series Installation guide
-
EnOcean Trio2Sys O2LINE 10020057 Series Installation guide
-
-
-
JUNG ENOLS995-01 Operating instructions
-
-
-
-