A B1
B2 C D
Phillips & Flathead screwdrivers required
Hardware Supplied
dowel
x12
30mm
screw x16
nut & bolt
set x9
50mm
screw x10
50mm
screw x9
*We recommend using a Flathead screwdriver to tighten all locking nuts 100% before first use.
Please clear any loose wood from the locking nut holes before inserting the nut to ensure it locks 100%.
For quicker assembly, we recommend the
use of a power drill on a low-speed setting.
E
feet
x4
Urban Coffee Table
1
mocka.co.nz | mocka.com.au
Assembly Instructions
Thank you for your purchase.
Please follow the instructions below for correct assembly.