SUBWOOFER POWER Fs Qts Vas (cu ft) SENSITIVITY LINEAR EXCURSION DIMENSIONS
CO104S 200 watts RMS/400 Max 39.2 Hz 0.57 1.080 86.1dB 10.29 mm 10.31” W x 5.12” D
CO124S 200 watts RMS/500 Max 38 Hz 0.49 4.017 87.2dB 10.41 mm 12.40” W x 5.51” D
CO154S 250 watts RMS/600 Max 25.2 Hz 0.47 7.098 89.9dB 11.50 mm 15.40” W x 6.46” D
AMPLIFIER POWER OUTPUT SIGNAL PROCESSING FUSE SIZE DIMENSIONS
CO300.2 2 x 55 @ 4 ohm / 2 x 75 @ 2 ohm Variable LP/HP 50Hz-500Hz, Selectable bass boost +12dB (1) 25 ATC 7.9” x 8.1” x 2.1”
CO600.2 2 x 100 @ 4 ohm / 2 x 150 @ 2 ohm Variable LP/HP 50Hz-500Hz, Selectable bass boost +12dB (2) 25 ATC 11.4” x 8.1” x 2.1”
CO600.4 4 x 60 @ 4 ohm / 4 x 75 @ 2 ohm Variable LP/HP 50Hz-500Hz, Selectable bass boost +8dB (2) 25 ATC 13.4” x 8.1” x 2.1”
CO500.1 1 x 175 @ 4 ohm / 1 x 250 @ 2 ohm Variable LP 50Hz-500Hz, 180° Phase Control, Bass Boost +12dB (2) 20 ATC 11.4” x 8.1” x 2.1”
CO800.1 1 x 300 @ 4 ohm / 1 x 400 @ 2 ohm Variable LP 50Hz-500Hz, 180° Phase Control, Bass Boost +12dB (2) 30 ATC 13.4” x 8.1” x 2.1”
SPEAKER POWER NOMINAL IMPEDANCE DESCRIPTION FREQ. RESPONSE SENSITIVITY DEPTH
CO652 50 watts RMS/120 Max 4 ohm 6.5” 2-Way Component Speaker 60Hz-20KHz 85dB 2.36”
CO552 40 watts RMS/100 Max 4 ohm 5.25” 2-Way Component Speaker 120Hz-20KHz 87dB 1.97”
CO690 60 watts RMS/130 Max 4 ohm 6” x 9” Coaxial Speaker 63Hz-20KHz 88.8dB 2.95”
CO650 50 watts RMS/120 Max 4 ohm 6.5” Coaxial Speaker 62Hz-20KHz 85.2dB 2.36”
CO600 40 watts RMS/100 Max 4 ohm 6” Coaxial Speaker 100Hz-20KHz 88.3dB 1.73”
CO570 40 watts RMS/100 Max 4 ohm 5” x 7” Coaxial Speaker 98Hz-20KHz 87.9dB 2.32”
CO500 40 watts RMS/100 Max 4 ohm 5.25” Coaxial Speaker 110Hz-20KHz 87.1dB 1.97”
Poly dust cap
Reversible
top gasket
face down
or up
Rigid UV coated
paper blend cone
with cross-vented
neck to keep
it cool
High roll
NBR foam
surround
Flat Conex
spider
with loop
stitched
tinsel leads
Autotension
push
terminal
4-layer copper
wound voice coil
on a cross-vented
Kapton former to
keep it cool
Custom
reinforced
stamped steel
basket with
rolled edges
Drilled and tapped
stamped steel
top plate
Large Ferrite
magnet
Magnet
boot
Bumped
back plate with
extended pole
for maximum
excursion
On-board
fusing
Angle lock power and
speaker terminals
Large MOSFET
power supply
Double-sided 2oz
copper PCB
High-level inputs
Auto Sense turn on
Variable low-pass
crossover
50Hz-500Hz
Remote bass
input
Full-range line out
Matched complimentary
Bipolar outputs
Large output filter
capacitors
ABS speaker grill
19mm metalized
poly dome
positionable
tweeter with
protection circuit
Multi-hole
top gasket
Paper/fiber cone with
NBR surround
Progressive
Conex spider
1” 2-layer copper
voice coil on a
Kapton former
Multi-hole
reinforced
stamped steel
basket with
rolled edges
Zinc-plated
top plate
Large Ferrite
magnet
Zinc-plated
back plate with
extended pole
for maximum
excursion
Designed and Engineered in USA by
directed i s a proud member o f
904F 12.07
© 2007 Directed Electronics. All Rights Reserved.
COBALT SUBWOOFERS FEATURE:
Reversible top gasket •
Large copper wound Kapton voice coil •
Autotension push terminals •
Flat Conex spider with loop stitched tinsel leads •
SUBWOOFERS
COBALT AMPLIFIERS - NEW!
Resurrected…Cobalt’s back…and coming after the other would-be players. With more
bass in your face, and more hard pounding watts for your hard-earned dollar!
Get a piece of the Orion legacy without breakin’ the bank – with COBALT.
Cobalt amplifiers feature flexible frontends with variable x-overs, selectable bass boost,
remote gain control (remote included on mono amplifiers), all poured into a small sleek
and sexy industrial design… Tons of clean power packed in a small package.
COBALT AMPLIFIERS FEATURE:
Small Proprietary Orion Industrial Design with illuminated design detail •
High-level inputs with auto turn-on circuit •
Flexible frontends to accommodate a variety of system configurations •
Excellent small signal parameters •
COBALT SUBWOOFERS - NEW!
Who knew that entry level subwoofers could
perform like this… These woofers will
absolutely blow your mind. With a bumped
back plate, extended pole piece, large
magnet, and high roll surround that give an
astounding 10.25mm of Xmax.
COBALT COMPONENTS AND COAXIALS
Speaker tuned for maximum performance whether
powered from a head unit or an amplifier you’ll get the
sound you just gotta have. With the recessed tweeters
and the universal baskets these speakers can be
dropped into almost any vehicle.
COBALT COMPONENTS FEATURE:
Progressive suspension •
1” voice coil (midrange driver) •
Built-in tweeter protection circuit •
COBALT COAXIALS FEATURE:
Progressive suspension •
1” voice coil (midrange driver) •
Positionable tweeters (except CO600) •
Built-in tweeter protection circuit •
AMPLIFIERS
COMPONENTS
AND COAXIALS