Greenheck Double Gland Axle Seal Replacement User manual

  • Hello! I am an AI chatbot trained to assist you with the Greenheck Double Gland Axle Seal Replacement User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Double Gland Axle Seal
Replacement Instructions
These instructions explain how to replace double gland axle seals in the field. Axle (shaft) penetrations through frame
are protected by double gland stuffing boxes. Tighten as required to prevent leakage around axle.
Caution: Over tightening will create excessive frictional torque and rapid packing wear.
1) Replaceable packing material may deteriorate due to wear, oxidation or exposure to adverse chemicals. Replace
as necessary. Greenheck provides a unique sealing construction with a two- piece packing clamp that splits to
allow easy access to the packing material. See Figure 1.
2) Remove
5
16 in. - 18 nuts and stainless steel retaining clips. Spread packing clamps and remove.
3) Remove old packing. In most installations, the packing cup can be pulled away from the damper frame to assist
packing removal.
4) Cut replacement packing material on a 45° angle. Form into a ring.
5) Install the two rings (glands) of packing into cup, staggering the splices half turn apart. The removable cups have
a ridge at the bottom to stop packing from passing through cup and to hold cup against damper frame.
6) Replace packing clamps against axle so they push against the packing.
7) Install stainless steel retaining clips and the two
5
16 in. - 18 nuts. Tighten by hand. It is difficult to specify required
tightening torque due to differences in axle diameters and packing materials but, packing should be below the top
of the cup.
5/16”-18 SS nut
Stuffing box retaining clip
5/16”-18 x 2 1/4” SS weldstud
Stuffing Box Assembly
Note: Turn packing material
to stagger splices 180°.
Packing Cup
Damper shaft
Packing material
(note splice orientation)
Packing clamps
Figure 1
• Double Gland Axle Seal Replacement, Rev 2, July 2020 Copyright 2020 © Greenheck Fan CorporationGFC
As a result of our commitment to continuous improvement, Greenheck reserves the right to change specifications
without notice.
Product warranties can be found online at Greenheck.com, either on the specific product page or in the
literature section of the website at Greenheck.com/Resources/Library/Literature.
®
Phone: 715.359.6171 • Fax: 715.355.2399 • Parts : 800.355.5354 • E-mail: [email protected] • Website: www.greenheck.com
Our Commitment
/