Allen-Bradley RediPANEL Installation guide

1 Publication 2705-IN006A-EN-P - September 2003

Installation Instructions

RediPANEL Mounting System

Introduction

This document covers the installation procedure to use when

mounting the following modules in a panel:

• Keypad Module (2705-K11Cx)

• NEMA Module (2705-P2xCx)

• 8/16/32 Type 800A Module (2705-P11*, -P21*, -P31*)

This procedure replaces a mounting bracket arrangement with studs

and nuts.

Mechanical Installation

The following procedure replaces the mechanical installation which

appears in the following publications:

• 2705-ND002 - RediPANEL Keypad Modules

• 2705-800 - RediPANEL Push Button Modules

During module installation, refer to the accompanying mounting

template for exact dimensions.

To install the module:

1. Cut an opening in the panel approximately

149 x 219 mm (h x w) or 5.86 x 8.61 in (h x w)

2. Drill four or six (as required) 0.250 in (6.4 mm) diameter holes

for the top and bottom mounting studs in the positions indicated

on the template.

ATTENTION

Hazardous voltage. Contact with voltage may cause

death or serious injury. Always disconnect power to

sign prior to servicing.

IMPORTANT

If you are installing the module in an existing cutout,

skip to step 3.

Publication 2705-IN006A-EN-P - September 2003 2 PN 41061-327-01(1)

3. Slide the module through the opening. The mounting tabs will

help seat the module tightly against a 0.062 in (1.6 mm) to 0.125

in (3.2 mm) thickness enclosure.

After sliding the module into the enclosure, the built-in

mounting tabs secure the module to the enclosure.

4. Install the mounting hardware and tighten to 8 in-lbs (0.908

N•m).