Wayne-Dalton 3995 User manual

  • Hello! I am an AI chatbot trained to assist you with the Wayne-Dalton 3995 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Antenna
(Not Included)
Connector
Mounting
Surface
Antenna
Bracket
Antenna
Cable
4
Thread connector onto antenna
and thread antenna cable onto
connector as shown.
Mount antenna straight. For
best reception, keep antenna
(not included) away from metal.
Antenna Extension Kit
Installation Instructions for Model 3995
for use with Wayne-Dalton
®
Radio Receivers
P.O. Box 67 Mt. Hope, OH 44660
1-800-676-7734
Package Contents:
1.12’ Antenna Cable
2. Connector
3. Antenna Bracket with Rubber Grommets
4. Manual
3.
2.
1.
323126
© Copyright 2005 Wayne-Dalton Corp.
New 5/17/2005
IMPORTANT NOTICE!
Read these instructions carefully before installing the
antenna extension kit. Pay close attention to all warnings
and notes. This manual should be retained for future
reference.
WARNING: To prevent
electrical shock, be
sure electrical power is
disconnected before
proceeding with
installation.
a. Remove antenna, if installed,
from external receiver and
retain for installation in step 4.
b. Connect antenna cable to
jack on external receiver.
Antenna Cable
Receiver
1
Metal Enclosure
Receiver
If receiver is installed in a
garage with metal siding, stucco
over metal lath, or thermal
reflective Tyvek, route the
antenna cable through the wall
to the exterior of the garage.
Ensure antenna cable is
secured and routed away from
any moving parts.
2
Mounting
Surface
Rubber
Grommets
Screws
(Not Included)
Antenna
Bracket
Locate a suitable flat mounting
surface on outside of building
to mount the antenna bracket
vertically.
Use screws (not included) or
other fastening means to attach
the antenna bracket to the
mounting surface.
NOTE: When mounting to metal
buildings, make sure rubber
grommets are in place and the
antenna bracket does not touch
the metal mounting surface.
This will ensure electrical (RF)
isolation and maximum signal
transmission range.
3

*./((/&+**./-0 /&+*.#+-4*"(/+*
5
!&+" "&1"-.
+!"(
+3/+,"


*/"**("
+**" /+-
*/"**- '"/
0"--+))"/.
*0(




333333
6+,4-&$%/4*"(/+*+-,
"2

"!/%"."&*./-0 /&+*. -"#0((4"#+-"&*./((&*$/%"
*/"**"3/"*.&+*'&/4 (+."//"*/&+*/+((2-*&*$.
*!*+/".%&.)*0(.%+0(!"-"/&*"!#+-#0/0-"
-"#"-"* "
'()-&+
%+)#%*"'$
*,)%+)#%('.)#*
#*'&&+ ')
()'#&!.#+"
#&*+%%+#'&
#+-3#,1#,,'$',01**#"
$/-+#51#/,*/#!#'3#/,"
/#1',$-/',01**1'-,',01#.
-,,#!1,1#,,! *#1-
(!)-,#51#/,*/#!#'3#/
,1#,, *#
#!#'3#/
)7%02'03685)
)')-9)5
*5)')-9)5-6-267%00)(-2%
+%5%+):-7,1)7%06-(-2+678''3
39)51)7%00%7,357,)51%0
5)= )'7-9)"<9)/5387)7,)
%27)22%'%&0)7,538+,7,):%00
737,));7)5-353*7
,)+%5%+)
2685)%27)22%'%&0)-6
6)'85)(%2(5387)(%:%<*531
%2<139-2+4%576
3827-2+
!85*%')
8&&)5
5311)76
!'5):6
372'08()(
27)22%
&5%'/)7
3'%7)%68-7%&0)13827-2+
685*%')73138277,)%27)22%
&5%'/)79)57-'%00<
#6)6'5):6237-2'08()(%2(
58&&)5+5311)763537,)5
*%67)2-2+1)%26
73%77%',7,)
%27)22%&5%'/)773%68-7%&0)
13827-2+685*%')
#6)-2680%7-2++531)76*35
1)7%0&8-0(-2+6*35-630%7-32 
26)57-273&5%'/)7
27)22%
372'08()(
322)'735
3827-2+
!85*%')
27)22%
5%'/)7
27)22%
%&0)
",5)%('322)'7353273%27)22%
%2(7,5)%(%27)22%'%&0)3273
'322)'735%66,3:2
3827%27)22%675%-+,735
&)675)')47-32/))4%27)22%
237-2'08()(%:%<*5311)7%0
4.
Nut from
Conntector
/