Panasonic EY0230 Owner's manual

Page is loading ...

— 2 —

Index/Index/Index/Indice/Inhoudsopgave/Indice/Indeks/Innehåll/Innhold/

Hakemisto/Индекс/Індекс

English: Page 3

Deutsch: Seite 8

Français: Page 12

Italiano: Pagina 16

Nederlands: Badzijde 20

Español: Página 24

Dansk: Side 28

Svenska: Sidan 32

Norsk: Side 36

Suomi: Sivu 40

Русский: Страница 44

Українська: Сторiнка 48

EY0225.BOOK Page 2 Saturday, June 18, 2005 1:16 PM

— 3 —

SAFETY

INSTRUCTIONS

Read All Instruction

1) SAVE THESE INSTRUCTIONS

This manual contains important safety

instructions for battery charger.

2) Before using battery charger, read all instruc-

tions and cautionary markings on (1) battery

charger, (2) battery pack.

3) CAUTION - To reduce the risk of injury,

charge only applicable battery pack. Other

types of batteries may burst causing personal

injury and damage.

4) Do not expose charger and battery pack to

rain or snow or use in damp location.

5) Use of an attachment not recommended may

result in a risk of fire, electric shock, or injury

to persons.

6) To reduce risk of damaging the electric plug

and cord, pull by plug rather than cord when

disconnecting charger.

7) An extension cord should not be used.

8) Do not operate charger with damaged cord or

plug - replace them immediately.

9) Do not operate charger if it has received a

sharp blow, been dropped, or otherwise dam-

aged in any way; take it to a qualified service

agent.

10) Do not disassemble charger; take it to a qual-

ified service agent when service or repair is

required. Incorrect reassembly may result in

a risk of electric shock or fire.

11) To reduce risk of electric shock, unplug

charger from outlet before attempting any

maintenance or cleaning.

12) Make sure cord is located so that it will not be

stepped on, tripped over, or otherwise sub-

jected to damage or stress.

13) The charger and battery pack are specifically

designed to work together. Do not attempt to

charge any other cordless tool or battery

pack with this charger. Do not attempt to

charge the battery pack with any other

charger.

14) Do not attempt to disassemble the battery

charger and the battery pack housing.

15) Do not store the tool and battery pack in loca-

tions where the temperature may reach or

exceed 50°C (122°F) (such as metal tool

shed, or a car in the summer), which can lead

to deterioration of the storage battery.

16) Do not charge battery pack when the temper-

ature is BELOW 0°C (32°F) or ABOVE 40°C

(104°F).

17) Do not incinerate the battery pack. It can

explode in a fire.

18) The charger is designed to operate on stan-

dard household electrical power only. Charge

only on the voltage indicated on the name-

plate. Do not attempt to use it on any other

voltage!

19) Do not abuse cord. Never carry charger by

cord or yank it to disconnect from outlet.

Keep cord away from heat, oil and sharp

edges.

20) Charge the battery pack in a well ventilated

place. Do not cover the charger and battery

pack with a cloth, etc., while charging.

21) Do not short the battery pack. A battery short

can cause a large current flow, over heating

and burns.

22) NOTE: If the supply cord of this appliance is

damaged, it must only be replaced by a

repair shop appointed by the manufacturer,

because special purpose tools are required.

23) The appliance is not intended for use by

young children or infirm persons without

supervision.

24) Young children should be supervised to

ensure that they do not play with the appli-

ance.

GB

EY0225.BOOK Page 3 Saturday, June 18, 2005 1:16 PM

— 4 —

CHARGING THE

BATTERY

Note: When you charge the battery pack for the

first-time, or after prolonged storage,

charge it for about 24 hours to bring the

batteries up to full capacity.

1. Plug the charger into an AC outlet.

EY0225:

• Sparks may be produced when the plug is

inserted into the AC power supply, but this

is not a problem in terms of safety.

2. Insert the battery pack firmly into the charger.

(* EY0230 is referred for illustration.)

EY0214:

• When charging, cooling fan in the charger

functions to cool down the battery pack, and

the sound of fan can be heard. This is nor-

mal. If this sound cannot be heard, it is a

malfunction. Stop charging immediately and

consult an authorized dealer.

3. During charging, the charging lamp will light

up. When the charge is completed, an internal

electronic switch will automatically be trig-

gered to prevent overcharging.

• Charging will not occur if the battery pack is

warm (for example, immediately after

heavy-duty operation). The orange standby

lamp will light up until the battery becomes

cool. Charging will then begin automatically.

4. When charging is completed, the charging

lamp will start flashing quickly.

EY0230/EY0214:

• When the battery pack has not been used

for a long time, the charging lamp starts

flashing slowly to indicate protective charg-

ing. Protective charging takes longer to fully

charge the battery pack, then the standard

charging time. (Max. charging time is

approx. 90 minutes.)

5. If a fully charged battery pack is inserted into

the charger again, the charging lamp may light

up. After several minutes, the charging lamp

may flash quickly to indicate the charging is

completed.

• If the charging lamp does not light immedi-

ately after the charger is plugged in, or if

after the standard charging time the lamp

does not go off, consult an authorized

dealer.

Note: • When a cold battery (of about 5°C or

less) is to be charged in a warm room,

leave the battery in the room for at least

one hour. Charge the battery when the

battery temperature has leveled with

room temperature. (Failing to do so may

result in less than a full charge.)

• Cool down the charger when charging

more than two battery packs consecu-

tively.

• Do not insert your fingers into contact

hole, when holding charger or any other

occasions.

CAUTION: • Do not use power source from an

engine generator.

• Do not cover vent holes on the

charger and the battery pack.

•

Unplug the charger when not in use.

1

2

Battry pack

To AC outlet

Battery charger

EY0225.BOOK Page 4 Saturday, June 18, 2005 1:16 PM

— 5 —

ELECTRICAL PLUG

INFORMATION

FOR YOUR SAFETY PLEASE READ

THE FOLLOWING TEXT CAREFULLY

This appliance is supplied with a moulded

three pin mains plug for your safety and

convenience.

A 3 amp fuse is fitted in this plug.

Should the fuse need to be replaced please

ensure that the replacement fuse has a rat-

ing of 3 amp and that it is approved by

ASTA or BSI to BS1362.

Check for the ASTA mark or the BSI

mark on the body of the fuse.

If the plug contains a removable fuse cover

you must ensure that it is refitted when the

fuse is replaced.

If you lose the fuse cover the plug must not

be used until a replacement cover is

obtained.

A replacement fuse cover can be pur-

chased from your local Panasonic Dealer.

IF THE FITTED MOULDED PLUG IS

UNSUITABLE FOR THE SOCKET OUTLET

IN YOUR HOME THEN THE FUSE

SHOULD BE REMOVED AND THE PLUG

CUT OFF AND DISPOSED OF SAFELY.

THERE IS A DANGER OF SEVERE ELEC-

TRICAL SHOCK IF THE CUT OFF PLUG

IS INSERTED INTO ANY 13 AMP

SOCKET.

If a new plug is to be fitted please observe

the wiring code as shown below.

If in any doubt please consult a qualified

electrician.

IMPORTANT: The wires in this mains lead

are coloured in accordance

with the following code:

Blue: Neutral

Brown: Live

As the colours of the wire in the mains lead

of this appliance may not correspond with

the coloured markings identifying the termi-

nals in your plug, proceed as follows.

The wire which is coloured BLUE must be

connected to the terminal in the plug which

is marked with the letter N or coloured

BLACK.

The wire which is coloured BROWN must

be connected to the terminal in the plug

which is marked with the letter L or coloured

RED.

Under no circumstances should either of

these wires be connected to the earth termi-

nal of the three pin plug, marked with the

letter E or the Earth Symbol .

How to replace the fuse: Open the fuse

compartment with a screwdriver and

replace the fuse and fuse cover if it is

removable.

ONLY FOR U. K.

This apparatus was produced to BS800.

Fuse Cover

EY0225.BOOK Page 5 Saturday, June 18, 2005 1:16 PM

— 6 —

LAMP INDICATIONS

EY0225

EY0230

EY0214

Flashing

Lit

Flashing quickly

Lit

Flashing

Charger is plugged into the AC outlet.

Ready to charge.

Now charging

Charging is completed

.

Battery pack is warm. Charging will begin

when temperature of battery pack drops.

Charging is not possible. Clogged with

dust or malfunction of the battery pack.

Charging

lamp

Re

d

Charging

lamp

Orange

Flashing

Lit

Flashing quickly

Flashing slowly

Lit

Flashing

Charger is plugged into a wall outlet.

Ready to charge.

Now charging

Charging is completed

Protective charging

Battery pack is warm. Charging will begin

when temperature of battery pack drops.

Charging is not possible. Clogged with

dust or malfunction of the battery pack.

Charging

lamp

Red

Standby

lamp

Orange

Flashing

Lit

Flashing quickly

Flashing slowly

Lit

Flashing

Charger is plugged into a wall outlet.

Ready to charge.

Now charging

Charging is completed

Protective charging

Battery pack is warm. Charging will begin

when temperature of battery pack drops.

Charging is not possible. Clogged with

dust or malfunction of the battery pack.

Charging lamp

Red

Standby

lamp

Orange

EY0225.BOOK Page 6 Saturday, June 18, 2005 1:16 PM

— 7 —

SPECIFICATIONS

Note: This chart may include models that are not available in your area.

Please refer to the catalogue.

Model EY0225 EY0230 EY0214

Weight 0.6 kg (1.3 lbs) 0.83 kg (1.83 lbs) 1.12 kg (2.47 lbs)

Electrical Rating See the name plate on the bottom of the charger.

Charging time

EY0225:

EY0230:

EY0214:

3.6 V 2.4 V Standard charging time

EY9025 EY9021 Approx : 15 min

15.6 V 12 V 9.6 V 7.2 V Standard charging time

-

EY9001

EY9006

EY9080

EY9068

EY9065

EY9066

Approx. 20 min.

- EY9101

EY9180

EY9182

- Approx. 25 min.

EY9136

EY9106

EY9107

EY9108

- EY9168 Approx. 30 min.

EY9230 EY9200 - - Approx. 45 min.

24 V 15.6 V 12 V 9.6 V 7.2 V Standard charging time

--

EY9001

EY9006

EY9080

EY9086

EY9065

EY9066

Approx. 20 min.

- - EY9101

EY9180

EY9182

- Approx. 25 min.

EY9117 EY9136

EY9106

EY9107

EY9108

- EY9168 Approx. 30 min.

EY9210 EY9230 EY9200 - - Approx. 45 min.

EY0225.BOOK Page 7 Saturday, June 18, 2005 1:16 PM

Page is loading ...

Matushita Electric Works, Ltd.

Osaka, Japan

No.1 EN. GN. FR. IT. ND. ES. DN. SW. NR. FN. RUS. Uk

EY971002304 H1706 Printed in Japan

EY0225.BOOK Page 52 Saturday, June 18, 2005 1:16 PM

Panasonic EY0230, EY0214, EY0225 Owner's manual

Related papers

Other documents