Panasonic EY0214 Owner's manual

Type
Owner's manual

This manual is also suitable for

2
Index/Index/Index/Indice/Inhoudsopgave/Indice/Indeks/Innehåll/Innhold/
Hakemisto/Индекс/Індекс
English: Page 3
Deutsch: Seite 8
Français: Page 12
Italiano: Pagina 16
Nederlands: Badzijde 20
Español: Página 24
Dansk: Side 28
Svenska: Sidan 32
Norsk: Side 36
Suomi: Sivu 40
Русский: Страница 44
Українська: Сторiнка 48
EY0225.BOOK Page 2 Saturday, June 18, 2005 1:16 PM
3
SAFETY
INSTRUCTIONS
Read All Instruction
1) SAVE THESE INSTRUCTIONS
This manual contains important safety
instructions for battery charger.
2) Before using battery charger, read all instruc-
tions and cautionary markings on (1) battery
charger, (2) battery pack.
3) CAUTION - To reduce the risk of injury,
charge only applicable battery pack. Other
types of batteries may burst causing personal
injury and damage.
4) Do not expose charger and battery pack to
rain or snow or use in damp location.
5) Use of an attachment not recommended may
result in a risk of fire, electric shock, or injury
to persons.
6) To reduce risk of damaging the electric plug
and cord, pull by plug rather than cord when
disconnecting charger.
7) An extension cord should not be used.
8) Do not operate charger with damaged cord or
plug - replace them immediately.
9) Do not operate charger if it has received a
sharp blow, been dropped, or otherwise dam-
aged in any way; take it to a qualified service
agent.
10) Do not disassemble charger; take it to a qual-
ified service agent when service or repair is
required. Incorrect reassembly may result in
a risk of electric shock or fire.
11) To reduce risk of electric shock, unplug
charger from outlet before attempting any
maintenance or cleaning.
12) Make sure cord is located so that it will not be
stepped on, tripped over, or otherwise sub-
jected to damage or stress.
13) The charger and battery pack are specifically
designed to work together. Do not attempt to
charge any other cordless tool or battery
pack with this charger. Do not attempt to
charge the battery pack with any other
charger.
14) Do not attempt to disassemble the battery
charger and the battery pack housing.
15) Do not store the tool and battery pack in loca-
tions where the temperature may reach or
exceed 50°C (122°F) (such as metal tool
shed, or a car in the summer), which can lead
to deterioration of the storage battery.
16) Do not charge battery pack when the temper-
ature is BELOW 0°C (32°F) or ABOVE 40°C
(104°F).
17) Do not incinerate the battery pack. It can
explode in a fire.
18) The charger is designed to operate on stan-
dard household electrical power only. Charge
only on the voltage indicated on the name-
plate. Do not attempt to use it on any other
voltage!
19) Do not abuse cord. Never carry charger by
cord or yank it to disconnect from outlet.
Keep cord away from heat, oil and sharp
edges.
20) Charge the battery pack in a well ventilated
place. Do not cover the charger and battery
pack with a cloth, etc., while charging.
21) Do not short the battery pack. A battery short
can cause a large current flow, over heating
and burns.
22) NOTE: If the supply cord of this appliance is
damaged, it must only be replaced by a
repair shop appointed by the manufacturer,
because special purpose tools are required.
23) The appliance is not intended for use by
young children or infirm persons without
supervision.
24) Young children should be supervised to
ensure that they do not play with the appli-
ance.
GB
EY0225.BOOK Page 3 Saturday, June 18, 2005 1:16 PM
4
CHARGING THE
BATTERY
Note: When you charge the battery pack for the
first-time, or after prolonged storage,
charge it for about 24 hours to bring the
batteries up to full capacity.
1. Plug the charger into an AC outlet.
EY0225:
Sparks may be produced when the plug is
inserted into the AC power supply, but this
is not a problem in terms of safety.
2. Insert the battery pack firmly into the charger.
(* EY0230 is referred for illustration.)
EY0214:
When charging, cooling fan in the charger
functions to cool down the battery pack, and
the sound of fan can be heard. This is nor-
mal. If this sound cannot be heard, it is a
malfunction. Stop charging immediately and
consult an authorized dealer.
3. During charging, the charging lamp will light
up. When the charge is completed, an internal
electronic switch will automatically be trig-
gered to prevent overcharging.
Charging will not occur if the battery pack is
warm (for example, immediately after
heavy-duty operation). The orange standby
lamp will light up until the battery becomes
cool. Charging will then begin automatically.
4. When charging is completed, the charging
lamp will start flashing quickly.
EY0230/EY0214:
When the battery pack has not been used
for a long time, the charging lamp starts
flashing slowly to indicate protective charg-
ing. Protective charging takes longer to fully
charge the battery pack, then the standard
charging time. (Max. charging time is
approx. 90 minutes.)
5. If a fully charged battery pack is inserted into
the charger again, the charging lamp may light
up. After several minutes, the charging lamp
may flash quickly to indicate the charging is
completed.
If the charging lamp does not light immedi-
ately after the charger is plugged in, or if
after the standard charging time the lamp
does not go off, consult an authorized
dealer.
Note: • When a cold battery (of about 5°C or
less) is to be charged in a warm room,
leave the battery in the room for at least
one hour. Charge the battery when the
battery temperature has leveled with
room temperature. (Failing to do so may
result in less than a full charge.)
Cool down the charger when charging
more than two battery packs consecu-
tively.
Do not insert your fingers into contact
hole, when holding charger or any other
occasions.
CAUTION: Do not use power source from an
engine generator.
Do not cover vent holes on the
charger and the battery pack.
Unplug the charger when not in use.
1
2
Battry pack
To AC outlet
Battery charger
EY0225.BOOK Page 4 Saturday, June 18, 2005 1:16 PM
5
ELECTRICAL PLUG
INFORMATION
FOR YOUR SAFETY PLEASE READ
THE FOLLOWING TEXT CAREFULLY
This appliance is supplied with a moulded
three pin mains plug for your safety and
convenience.
A 3 amp fuse is fitted in this plug.
Should the fuse need to be replaced please
ensure that the replacement fuse has a rat-
ing of 3 amp and that it is approved by
ASTA or BSI to BS1362.
Check for the ASTA mark or the BSI
mark on the body of the fuse.
If the plug contains a removable fuse cover
you must ensure that it is refitted when the
fuse is replaced.
If you lose the fuse cover the plug must not
be used until a replacement cover is
obtained.
A replacement fuse cover can be pur-
chased from your local Panasonic Dealer.
IF THE FITTED MOULDED PLUG IS
UNSUITABLE FOR THE SOCKET OUTLET
IN YOUR HOME THEN THE FUSE
SHOULD BE REMOVED AND THE PLUG
CUT OFF AND DISPOSED OF SAFELY.
THERE IS A DANGER OF SEVERE ELEC-
TRICAL SHOCK IF THE CUT OFF PLUG
IS INSERTED INTO ANY 13 AMP
SOCKET.
If a new plug is to be fitted please observe
the wiring code as shown below.
If in any doubt please consult a qualified
electrician.
IMPORTANT: The wires in this mains lead
are coloured in accordance
with the following code:
Blue: Neutral
Brown: Live
As the colours of the wire in the mains lead
of this appliance may not correspond with
the coloured markings identifying the termi-
nals in your plug, proceed as follows.
The wire which is coloured BLUE must be
connected to the terminal in the plug which
is marked with the letter N or coloured
BLACK.
The wire which is coloured BROWN must
be connected to the terminal in the plug
which is marked with the letter L or coloured
RED.
Under no circumstances should either of
these wires be connected to the earth termi-
nal of the three pin plug, marked with the
letter E or the Earth Symbol .
How to replace the fuse: Open the fuse
compartment with a screwdriver and
replace the fuse and fuse cover if it is
removable.
ONLY FOR U. K.
This apparatus was produced to BS800.
Fuse Cover
EY0225.BOOK Page 5 Saturday, June 18, 2005 1:16 PM
6
LAMP INDICATIONS
EY0225
EY0230
EY0214
Flashing
Lit
Flashing quickly
Lit
Flashing
Charger is plugged into the AC outlet.
Ready to charge.
Now charging
Charging is completed
.
Battery pack is warm. Charging will begin
when temperature of battery pack drops.
Charging is not possible. Clogged with
dust or malfunction of the battery pack.
Charging
lamp
Re
d
Charging
lamp
Orange
Flashing
Lit
Flashing quickly
Flashing slowly
Lit
Flashing
Charger is plugged into a wall outlet.
Ready to charge.
Now charging
Charging is completed
Protective charging
Battery pack is warm. Charging will begin
when temperature of battery pack drops.
Charging is not possible. Clogged with
dust or malfunction of the battery pack.
Charging
lamp
Red
Standby
lamp
Orange
Flashing
Lit
Flashing quickly
Flashing slowly
Lit
Flashing
Charger is plugged into a wall outlet.
Ready to charge.
Now charging
Charging is completed
Protective charging
Battery pack is warm. Charging will begin
when temperature of battery pack drops.
Charging is not possible. Clogged with
dust or malfunction of the battery pack.
Charging lamp
Red
Standby
lamp
Orange
EY0225.BOOK Page 6 Saturday, June 18, 2005 1:16 PM
7
SPECIFICATIONS
Note: This chart may include models that are not available in your area.
Please refer to the catalogue.
Model EY0225 EY0230 EY0214
Weight 0.6 kg (1.3 lbs) 0.83 kg (1.83 lbs) 1.12 kg (2.47 lbs)
Electrical Rating See the name plate on the bottom of the charger.
Charging time
EY0225:
EY0230:
EY0214:
3.6 V 2.4 V Standard charging time
EY9025 EY9021 Approx : 15 min
15.6 V 12 V 9.6 V 7.2 V Standard charging time
-
EY9001
EY9006
EY9080
EY9068
EY9065
EY9066
Approx. 20 min.
- EY9101
EY9180
EY9182
- Approx. 25 min.
EY9136
EY9106
EY9107
EY9108
- EY9168 Approx. 30 min.
EY9230 EY9200 - - Approx. 45 min.
24 V 15.6 V 12 V 9.6 V 7.2 V Standard charging time
--
EY9001
EY9006
EY9080
EY9086
EY9065
EY9066
Approx. 20 min.
- - EY9101
EY9180
EY9182
- Approx. 25 min.
EY9117 EY9136
EY9106
EY9107
EY9108
- EY9168 Approx. 30 min.
EY9210 EY9230 EY9200 - - Approx. 45 min.
EY0225.BOOK Page 7 Saturday, June 18, 2005 1:16 PM
Matushita Electric Works, Ltd.
Osaka, Japan
No.1 EN. GN. FR. IT. ND. ES. DN. SW. NR. FN. RUS. Uk
EY971002304 H1706 Printed in Japan
EY0225.BOOK Page 52 Saturday, June 18, 2005 1:16 PM
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32
  • Page 33 33
  • Page 34 34
  • Page 35 35
  • Page 36 36
  • Page 37 37
  • Page 38 38
  • Page 39 39
  • Page 40 40
  • Page 41 41
  • Page 42 42
  • Page 43 43
  • Page 44 44
  • Page 45 45
  • Page 46 46
  • Page 47 47
  • Page 48 48
  • Page 49 49
  • Page 50 50
  • Page 51 51
  • Page 52 52

Panasonic EY0214 Owner's manual

Type
Owner's manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI