RiteTemp 8029B Operating instructions

Brand
RiteTemp
Model
8029B
Category
Thermostats
Type
Operating instructions
PG 1
PG 2
HE
A
T
CO
OL
A
UTO
ON
O
F
F
F
AN
TEMP
UP button
TEMP
DOWN button
Temperature
Display
Farenheit/Celcius
indicator
HEAT/COOL
Mode Switch
Fan
Switch
RESET
button
Current Temperature
Display
SET Temperature
Display
Operation 8029B
Statement of use: The 8029B can be used with most 24
volt gas, oil or electric heating and air conditioning systems,
single-stage heat pumps or gas millivolt heating systems. It
cannot be used with 120 volt heating systems or
multistage heat pumps.
1 Configure
Set HEAT/COOL mode switch to HEAT or COOL. The unit will display the ambient
temperature. Set the Fan switch to automatic.
Your thermostat is now in operation.
In the winter, set the system switch to HEAT to control your heating system.
In the summer, set the system switch to COOL to control your air conditioner.
In spring and fall or when windows are open, you can set the system switch OFF.
Setting the FAN switch to AUTO automatically runs your system's fan during heating and
cooling.
Setting the FAN switch to ON runs your system's fan continuously even without heating
or cooling.
2 Set Temp
3 Operate
Press the TEMP UP and TEMP DOWN buttons to select the desired temperature.
The SET icon will be displayed with your desired temperature. ( The display will return to
the current temperature in 5 sec if no button is pressed).
RO
O
M
T
E
MP
H
E
AT
ROOM TEMP TARGET TEMP
4 Special Features
PG 3
PG 4
GAS
OPEN F
SHORT C
ELECT
AA
AA
Fahrenheit
/Celsius jumper
Gas/Electric jumper
Customer Support: 888-515-2585
Visit our webiste www.ritetemp-thermostats.com
307-008
OFF ON
ADJ RM TEMP
Rear View of Unit
F
0
/ C
0
Select
Centigrade / Fahrenheit selection. The C/F jumper is on the back of the
thermostat control unit it determines which temperature system is
displayed on the LCD display.
To change the F
0
/ C
0
jumper. Separate the control unit from the wall
mounted terminals. Locate the F
0
/ C
0
jumper .
Select the desired display mode.
Replace the control unit on the wall and press RESET.
Low Battery
When the batteries are low, the battery icon will come on and flash.
The two AA Batteries in the unit need to be replaced. In some
installations your heater system will stop functioning when the thermostat
loses power. Replace batteries as soon as you see this warning. The
thermostat setting will remain for 30 seconds while the batteries are
removed and replaced.
Calibration
switch
  • Page 1 1
  • Page 2 2

RiteTemp 8029B Operating instructions

Brand
RiteTemp
Model
8029B
Category
Thermostats
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents