Gorilla Playsets 04-0036-G Operating instructions

Disc Swing

NE 4566L

KIT INCLUDES:

QTY DESCRIPTION

1 Disc Swing Seat

1 Loc Nut

1 Washer

1 Bolt Cover

2 2” Galvanized Screws

INSTRUCTIONS

1. Measure and mark the bottom of the swing beam a

minimum of 15" from the nearest swing or edge of

the unit on each side as shown in Figure 1.

2. Drill one 5/16" hole up through the beam at the mark

made in Step 1. Attach the rope to the swing beam

by slipping the eye bolt through the hole and secure

it with a 5/16" flat washer and loc nut. Place a bolt

cover over the exposed bolt end and secure it using

two 2” galvanized screws (see Figure 1).

Fig. 1

PlayCore Printed in USA LA 5240

Minimum 15” to

next Swing or

edge of unit

swing beam

Bolt Cover

2” galvanized

screws

Loc Nut

Washer

Minimum 15” to

next Swing or

edge of unit