BACK TO
NATURE
SAFER DEGLOSSER
TM
DEGLOSSES & CLEANS
WITHOUT SAND
ING
TECHNICAL DATA SHEET
I. Description: Back to Nature Safer
Deglosser
TM
is a water-based,
biodegradable, non flammable, paint
deglosser. It deglosses and cleans without
sanding. As a surface preparation product, it
helps new paint and varnish adhere to
existing finishes. It is also a superior
multipurpose cleaner on grease, grime, stains
and unwanted spots. It is designed to react
quickly and work efficiently.
II. Instructions:
1. Back to Nature Safer Deglosser
should be used full strength.
2. Clean off surface dirt using a damp
cloth.
3. Spray Back to Nature Deglosser onto
the surface.
4. Work in with a brush or pad if
necessary.
5. Allow Back to Nature Safer Deglosser
to dwell on the surface approximately
10-15 minutes.
6. While surface is still wet, wipe down
with a dry cloth. If Back to Nature
Safer Deglosser had dried on the
surface, wipe down with a wet sponge
and allow to dry.
7. Let dry approximately 1 hour before
applying new finish.
8. Inspect visually. Use second
application when necessary.
III. Safety Instructions: Safety goggles or
face shield are recommended for eye
protection. Rubber gloves are
recommended. In case of eye contact flush
with plenty of cool water for 15 minutes, lift
lids, do not rub. Get medical attention. In
case of ingestion, drink water or milk to dilute.
Do not induce vomiting. Get medical
attention immediately.
BACK TO NATURE PRODUCTS CO.
28 HARRISON AVE. SUITE 238 ENGLISHTOWN NJ 07726, 732-792-2001. FAX 732-792-8344
-
1
