Thinset Removal Bit 4TRBRS User manual

Item: 4 in. x 7.5 in. Round Shank Scaling Chisel

Brand: THINSET REMOVAL BIT®

Manufacturer: Thinset Removal LLC

Part #: 4TRBRS

Use and Care Instructions:

• Always wear appropriate safety equipment (goggles, dust mask, ear protection) when

operating

• Before use inspect for any manufacturing defects (i.e cracks). If any are discovered dis-

continue use

• Always exercise caution when operating

• Ensure chisel is properly secured in compatible (0.401 in.) air hammer

• Apply 2-3 drops of air tool oil (not included) into air hammer inlet before use

• Operating pressure 70-90 PSI, verify compatibility with air hammer manual.

• Recommended angle of attack 40-60 degrees in relation to floor