Stove Pipe, Fittings &
Accessory Installation
Installation Requirements
Check your local building code for additional requirements.
• Minimum clearance to combustible material is 18 inches.
• Each joint in the assembly must be joined with at least three self-tapping screws.
• Seal any gaps with a high temperature silicone sealant to prevent flue gases from escaping
Stove Pipe and Telescopic Stove Pipe
• Used to connect woodstove to entrance of chimney
• The crimped end should be oriented toward the stove to allow for condensation and
creosote to flow down inside the pipe
• Easy to close snap lock system
• Telescopic pipe eliminates joints and the need to cut pipe
Adjustable Elbows (45° and 90°)
• Used to connect two lengths of flue pipe together
• Allows the stove to be offset from directly under or in front of the chimney
• Adjustable from 0° to 45°; 0° to 90°
Slip Connector
• Allows connection between two pipe joints without cutting pipe
Assembled Tees & End Caps
• Used with rear outlet stoves and for a clean out
• Closes off one end of an assembled tee
Increaser / Reducer
• Used to change flue pipe size
Trim Collars / Flue Stop
• Provides a finished appearance where flue pipe connects to chimney
• Used to cover existing flue hole
/
