Speedi-Products SP-24BSP 06 Operating instructions

Stove Pipe & Accessory

Instructions

Installation Requirements

Check your local building code for additional requirements.

• Minimum clearance to combustible material is 18 inches.

• Each joint in the assembly must be joined with at least three self-tapping screws.

Stove Pipe and Telescopic Stove Pipe

• Used to connect woodstove to entrance of chimney

• The crimped end should be oriented toward the stove to allow for condensation and

creosote to flow down inside the pipe

• Easy to close snap lock system

• Telescopic pipe eliminates joints and the need to cut pipe

Adjustable Elbows (45° and 90°)

• Used to connect two lengths of flue pipe together

• Allows the stove to be offset from directly under or in front of the chimney

• Adjustable from 0° to 45°; 0° to 90°

Slip Connector

• Allows connection between two pipe joints without cutting pipe

Assembled Tees & End Caps

• Used with rear outlet stoves and for a clean out

• Closes off one end of an assembled tee

Increaser / Reducer

• Used to change flue pipe size

Trim Collars / Flue Stop

• Provides a finished appearance where flue pipe connects to chimney

• Used to cover existing flue hole