Homelite ut40520 Owner's manual

Brand: Homelite

Model: ut40520

Type: Owner's manual

991000547

6-12-15 (REV:01)

Add entire bottle of lubricant provided to the unit

(see page 12).

WARNING:

This Quick Reference Guide is not a substitute for reading the operator’s manual. To reduce the risk of injury or death, user must read and understand operator’s manual before using this product. All page references refer to

the operator’s manual.

FIRST TIME ASSEMBLY

UT40520 QUICK REFERENCE GUIDE

STARTING THE UNIT

USING THE WATER PUMP

STORING THE UNIT

1 4

Attach suction hose (not included) to strainer using

a hose clamp (see page 10).

Connect suction hose (not included) to water

source (see page 11).

Attach suction hose (not included) to pump inlet

(see page 10).

Attach discharge hose (not included) to pump outlet

(see page 11).

Add fuel (see page 12).

Prime the water pump (see page 13).

Move the fuel lever to CLOSED before adding

lubricant.

Set unit on flat surface so engine is level.

Remove dipstick, wipe clean, put back in hole

(but don’t screw in) and check lubricant level.

This is a 4-cycle engine. Do not mix fuel and lu-

bricant together.

Mix fuel stabilizer with gasoline according to

manufacturer’s directions prior to filling the

tank.

STOPPING THE UNIT

Put the engine switch in the OFF position (see page 13).

Follow all instructions and rules when using the water pump (see pages 3 - 5).

• Do not start or operate the engine in a confined space, building, near open windows, or in other unventilated

space where dangerous carbon monoxide fumes can collect.

• Do not use this product to pump acids, alkalines, solvents, flammable material, bleaches, or industrial grade

solutions.

• Secure the pump to reduce the risk of injury or property damage due to unexpected tool movement. If any

tipping or walking is noticed, stop operation and anchor the pump to prevent movement.

• Do not operate the pump unless a filtered suction hose is attached and connected to a water source.

• Secure the discharge hose. An unsecured hose may whip or “kick back” during operation and cause serious

personal injury.

• For maximum suction, keep the distance from the pump and water source as short as possible.

• Avoid running the tool at low or high speeds for extended periods of time as this may damage the pump.

When preparing to store the water pump, allow the unit to cool for five minutes, then follow the guidelines listed

on pages 15 and 16.

TROUBLESHOOTING

NOTICE:

Always observe all local regulations

when discharging pumped water.

Some areas have restrictions against

discharging pumped water. Check with

the appropriate authorities before using

this water pump.

IMPORTANT!

Only use OUTSIDE and

far away from windows,

doors, and vents.

NEVER use inside a home

or garage, EVEN IF doors

and windows are open.

Using a gas water pump indoors CAN KILL YOU IN MINUTES. Engine exhaust

contains carbon monoxide. This is a poison you cannot see or smell. Use

sufficient hose length to keep pump at least 20 feet (6 meters) away from

all windows, doors, and vents. Direct engine exhaust away from all

windows, doors, and vents.

Move throttle lever to the RIGHT (see page 13).

Move the choke to the START position (see page 13).

Move the fuel lever to the OPEN position (see page 13).

Put the engine switch in the ON position

(see page 13).

Pull the starter grip and rope until the engine runs

(see page 13).

NOTICE:

Do not use E15

or E85 fuel in

this product. It is a violation of federal

law and will damage the unit and void

your warranty. Only use unleaded gaso-

line containing up to 10% ethanol.

ENGINE SWITCH

(ON POSITION)

ENGINE SWITCH

(OFF POSITION)

PULL

STARTER GRIP AND

ROPE TO START

THROTTLE LEVER (FULLY RIGHT)

CHOKE (START POSITION)

FUEL LEVER (OPEN POSITION)

Make the most of your purchase! Go to www.homelite.com and

or maintaining your product, please call, 1-800-242-4672.

PROBLEM CAUSE SOLUTION

Engine will not start No fuel in tank

Spark plug shorted or fouled

Spark plug is broken (cracked porcelain or

electrodes broken)

Ignition lead wire shorted, broken, or discon-

nected from spark plug

Ignition inoperative

Choke lever is in RUN position

Fill tank.

Replace spark plug.

Replace lead wire or attach to spark plug.

Contact qualified service center.

Move choke lever to START position.

Engine hard to start Water in gasoline

Weak spark at spark plug

Drain entire system and refill with fresh fuel.

Contact qualified service center.

Engine lacks power Dirty air filter Clean or replace air filter.

Output lower than normal Connections leaking

Throttle lever pushed to the right

Suction hose damaged or leaking

Discharge hose damaged or leaking

Tighten connections.

Push throttle lever to the left.

Replace suction hose.

Replace discharge hose.

If problem persists after trying the above solutions, contact customer service or a qualified service center for assistance.

NOTICE:

As the equipment owner, you are responsible for the performance of the required maintenance listed in the Maintenance

section It is recommended that you retain all receipts covering maintenance on your equipment. Neglecting or failing to

perform the required maintenance may increase emissions, decrease fuel efficiency, degrade performance, cause irreversible

engine damage and/or void your warranty.

Homelite ut40520 Owner's manual

Homelite ut40520 Owner's manual

Homelite ut40520 Owner's manual

Related papers

Other documents