Lee Precision 90194 Long Charging Die Operating instructions

1.24.22 Lee Precision, Inc. 0464 CHECKED BY

LD1489 LongChgDie Instruction 90194 mjh

34307901 94 3

734307901 94 3

LONG CHARGING DIE

FITS Case Length 1.760“ TO 2.620“

223 Rem. to 300 Win. Mag.

➊ Screw the charging die into your powder

measure, verify the actuator drop tube is inside.

➋ Adjust powder measure with empty case in the

shell holder and ram fully raised. Screw unit into

the press just enough to fully move the disk or

drum to the dump position.

WARNING This product may contain steel alloyed with trace amounts of lead and

other elements which are known to the State of California to cause reproductive

harm and cancer. For more information, go towww.P65Warnings.ca.gov.

To prevent exposure, do not alter the product by welding, grinding, etc.

Put case in shellholder,

raise ram to top of

stroke, screw die in until

you feel the case mouth

bottom out against the

riﬂe drop tube.

INSTRUCTIONS

LD1489

4275 COUNTY ROAD U

HARTFORD WI 53027

LONG CHARGING DIE

FOR USE WITH LEE PRO AUTO-DISK

AND AUTO-DRUM POWDER MEASURES DIPPING POWDER CHARGE

BY HAND

www.leeprecision.com

Download PDF