2. BEA
  3. ULTIMO IXIO Universal Rain Accessory
ULTIMO IXIO Universal Rain Accessory

BEA ULTIMO IXIO Universal Rain Accessory Operating instructions

  • Hello! I've reviewed the provided document which is an installation guide for the Universal Rain Accessory for BEA's ULTIMO and IXIO sensors. This accessory is designed for rain protection and the document includes important steps for mounting, wiring, and ensuring safety compliance. I'm ready to answer any questions you have about the installation process or features described in the manual.
  • What sensors are compatible with this accessory?
    What is the maximum distance the bottom of the ULTIMO sensor can be from the door header?
    What is the maximum distance the bottom of the IXIO sensor can be from the door header?
©BEA | Original Instructions
75.0056.02 UNIVERSAL RAIN ACCESSORY 20221215 Page 1 of 2
Bracket accessory for ULTIMO and IXIO sensors
ENGLISH
Visit website for available
languages of this document.
base
cover
sensor not included
BEA, Inc., the sensor manufacturer, cannot be held responsible for incorrect installations or incorrect adjustments of the sensor/device; therefore, BEA, Inc. does not guarantee any use of the sensor/
device outside of its intended purpose.
BEA, Inc. strongly recommends that installation and service technicians be AAADM-certifi ed for pedestrian doors, IDA-certifi ed for doors/gates, and factory-trained for the type of door/gate system.
Installers and service personnel are responsible for executing a risk assessment following each installation/service performed, ensuring that the sensor/device system performance is compliant with local,
national, and international regulations, codes, and standards.
Once installation or service work is complete, a safety inspection of the door/gate shall be performed per the door/gate manufacturer’s recommendations and/or per AAADM/ANSI/DASMA guidelines
(where applicable) for best industry practices. Safety inspections must be performed during each service call – examples of these safety inspections can be found on an AAADM safety information label
(e.g. ANSI/DASMA 102, ANSI/DASMA 107, UL294, UL325, and International Building Code).
Verify that all appropriate industry signage, warning labels, and placards are in place.
BEA, INC. INSTALLATION/SERVICE COMPLIANCE EXPECTATIONS
Tech Support & Customer Service: 1-800-523-2462 | General Tech Questions: [email protected] | Tech Docs: www.BEAsensors.com
UNIVERSAL RAIN ACCESSORY
1
3
4
75.0034.05 ULTIMO 20220708 Page 1 of 20
ULTIMO
EN
ACTIVATION AND SAFETY SENSOR FOR
AUTOMATIC, SLIDING DOORS
Software version 2.5 / Configuration version 7.0
(refer to Admin menu for product software vesion)
Visit website for
available languages
of this document.
5 6
2
©BEA | Original Instructions
75.0056.02 UNIVERSAL RAIN ACCESSORY 20221215 Page 2 of 2
MOUNTING & ASSEMBLY
1. Verify the existing mounting location orientation:
• ULTIMO: the bottom of the sensor is no more than 5” from
the bottom of the door header
• IXIO: the bottom of the sensor is no more than 2” from the
bottom of the door header
3. Secure the URA base to the mounting location using the provided
screws.
4. Secure the sensor to the URA base using the screws provided
with the sensor.
5. Wire as instructed in the applicable sensor’s User’s Guide and
secure the sensor cover.
6. Slightly pull the sides of the cover and insert the pin guides on
the inside of the URA cover into the outside of the URA base.
2. Place the Universal Rain Accessory (URA) base in the desired
mounting location, and mark and drill pilot holes. Remove
existing sensor if necessary.
/