Page: - 3 - / 4
^ƚĞƉϭ͗LJŵĞĂƐƵƌŝŶŐ͕ĚĞƚĞƌŵŝŶĞƚŚĞĐŽƌƌĞĐƚŶƵŵďĞƌŽĨůŝŶŬƐŶĞĞĚĞĚĨŽƌƉƌŽƉĞƌŚĂŶŐŝŶŐŚĞŝŐŚƚ͘hƐŝŶŐƚŚĞĐŚĂŝŶƉůŝĞƌƐ͕
ĚŝƐĐŽŶŶĞĐƚĂŶĚĚŝƐĐĂƌĚƚŚĞƵŶǁĂŶƚĞĚƉĂƌƚ͘
^ƚĞƉϮ͗^ĐƌĞǁƚŚĞůŽŽƉ;:ͿŽŶƚŽƚŚĞůŝĚ;<Ϳ͘
ƚƚĂĐŚƚŚĞƋƵŝĐŬůŝŶŬ;,ͿƚŽĐŽŶŶĞĐƚƚŚĞĐŚĂŝŶ;/ͿĂŶĚƚŚĞůŽŽƉ;:ͿŽŶƚŚĞƚŽƉŽĨ ůŝĚ;<Ϳ͘
^ƚĞƉϯ͗ĂƌĞĨƵůůLJǁĞĂǀĞƚŚĞǁŝƌĞƐƚŚƌŽƵŐŚƚŚĞĐŚĂŝŶ;/ͿŝŶĂŶĚŽƵƚŽĨĞǀĞƌLJŽƚŚĞƌůŝŶŬĂŶĚƐƚŽƉũƵƐƚǁŚĞŶLJŽƵ
ƌĞĂĐŚƚŚĞƚŽƉŽĨĐŚĂŝŶ;/Ϳ͘'ĞŶƚůLJƉƵůůƚŚĞǁŝƌĞƐƚŽĞŶƐƵƌĞƚŚĞǁŝƌĞƐĂƌĞŶŽƚƐƚƌĞƐƐĞĚ͘
ϯ͘ dƵƌŶŽĨĨƉŽǁĞƌ
ĞĨŽƌĞLJŽƵƐƚĂƌƚƚŚĞŝŶƐƚĂůůĂƚŝŽŶ͕EsZĂƚƚĞŵƉƚĂŶLJǁŽƌŬǁŝƚŚŽƵƚƐŚƵƚƚŝŶŐŽĨĨƚŚĞĞůĞĐƚƌŝĐŝƚLJƵŶƚŝůƚŚĞǁŽƌŬŝƐ
ĚŽŶĞ͘
Ϳ 'ŽƚŽƚŚĞŵĂŝŶĨƵƐĞ͕ŽƌĐŝƌĐƵŝƚďƌĞĂŬĞƌ͕ďŽdžŝŶLJŽƵƌŚŽŵĞ͘WůĂĐĞƚŚĞŵĂŝŶƉŽǁĞƌƐǁŝƚĐŚŝŶƚŚĞ͞K&&͟ƉŽƐŝƚŝŽŶ͘
Ϳ WůĂĐĞƚŚĞǁĂůůƐǁŝƚĐŚŝŶƚŚĞ͞K&&͟ƉŽƐŝƚŝŽŶ͘
ϰ͘ DĂŬĞŝŶƐƚĂůůĂƚŝŽŶ
Step 1: Remove the ĐŽůůĂƌ ring (&) from collar loop('). Attach the single bar () to outlet box with mounting screws (B).
EŽƚĞ͗ďĞƐƵƌĞƚŚĂƚƚh
he side of single bar marked "GND" must face out
͘
Step 2: Pass canopy () over the mounted collar loop (') then secure with ĐŽůůĂƌ ring (&) to ĐŚĞĐŬƚŚĞƉƌŽƉĞƌƉŽƐŝƚŝŽŶ.
dŚĞŶƵnscrew ĐŽůůĂƌƌŝŶŐ;&ͿĨƌŽŵĐŽůůĂƌůŽŽƉ;'ͿĂŶĚƌĞŵŽǀĞƚŚĞĐĂŶŽƉLJ;Ϳ͘ZĞĨĞƌƚŽƚŚĞĨŽůůŽǁŝŶŐŶŽƚĞ͕LJŽƵ
ǁŽƵůĚŬŶŽǁƚŚĞƉƌŽƉĞƌƉŽƐŝƚŝŽŶǁŚĞƌĞĐŽůůĂƌůŽŽƉ;'ͿƐŚŽƵůĚďĞůŽĐĂƚĞĚ͘
Note: The canopy () should be snug against the ceiling and the collar loop (') should be screwed enough
threads (no less than 6 threads)ŽŶƚŽ the ƉƌĞͲĂƐƐĞŵďůĞĚthreaded nipple for more secure hanging.If not,
adjust the ƉƌĞͲĂƐƐĞŵďůĞĚƚŚƌĞĂĚĞĚŶŝƉƉůĞ and collar loop (') until the ƐĞĐƵƌĞ height is reached.
dŚĞŶƌemove the ĐŽůůĂƌ ring (&) and canopy()͕ĂŶĚƐĞƚĂsideĨŽƌƚŚĞĨŽůůŽǁŝŶŐƐƚĞƉƐ.
Step 3: Slip the ĐŽůůĂƌ ring(&) over the chain(/),then do the same with the canopy().
Step 4: Open the quick link(,)attach the quick link (,) to connect the loop ('). Close the quick link(,)͘Pass the
wires ĨƌŽŵƚŚĞĐŚĂŝŶ;/ͿƚŽƚŚĞ collar loop(') ĂŶĚthe top of ƉƌĞͲĂƐƐĞŵďůĞĚƚŚƌĞĂĚĞĚŶŝƉƉůĞand gently pull
ƚŚĞǁŝƌĞƐƚŽĞŶƐƵƌĞƚŚĞǁŝƌĞƐĂƌĞŶŽƚƐƚƌĞƐƐĞĚ.
Step5: If needed, ƐŚŽƌƚĞŶ thelength of fixtureǁŝƌĞƐ.At this point, the remaining wire length measured ĂďŽǀĞƚŚĞ
ƐŝŶŐůĞďĂƌ;ͿŝƐĂƚůĞĂƐƚϲΗ͘