Chore-Time MT2330A CHORE-TRONICS® 20 Amp Variable Speed Kit Operating instructions

Brand
Chore-Time
Model
MT2330A CHORE-TRONICS® 20 Amp Variable Speed Kit
Type
Operating instructions
Caution, Warning and Danger Decals have been placed on the equipment to warn of
potentially dangerous situations. Care should be taken to keep this information intact and easy
to read at all times. Replace missing or damaged safety decals immediately.
DANGER: Electrical Hazard
Disconnect electrical power before inspecting or servicing equipment unless
maintenance instructions specifically state otherwise. Ground all electrical
equipment for safety. All electrical wiring must be done by a qualified electrician in
accordance with local and national electric codes. Ground all non-current carrying
metal parts to guard against electrical shock. With the exception of motor overload
protection, electrical disconnects and over current protection are not supplied with
the equipment.
Variable Speed Kit (pn 42520) Wiring.
20 Amp Variable
Speed Kit Instruction
Mount the VSM Modules
To the Metal Base Plate with
the Black Plastic Mounting
Connectors supplied with the Kit.
Switches
Set For Var. Sp. #1
This End of the Flat Cable
Hangs Loose.
Use the Short PVC
Conduit supplied with
the Kit to Connect the
PB 20 to the Control
(
Do Not
mount the PB 20
Farther away than the Conduit
will allow.)
Do Not Route any
other Wires than those
shown through the Conduit.
Connect the Flat Cable Supplied with the Kit from
the I/O Board to the Variable Speed Modules as shown.
I/O BOARD
12
FULL LOAD
MAXIMUM
20 AMPS
(230 VAC)
VARIABLE
SPEED
FAN(S) #1
L1
L2
PB 20 CONTROL
L N Z U V PE
230 VAC
CIRCUIT
BREAKER
FOR
VAR SPEED
FAN(S) #1
Z U V
MT2330AMarch 2009
2
MT2330A
Variable Speed Kit pn (42522) Wiring
CTB Inc.
P.O. Box 2000 • Milford, Indiana 46542-2000 • U.S.A.
Phone (574) 658-4101 • Fax (877) 730-8825
Email: ctb@ctbinc.com • Internet: http//www.ctbinc.com
MOUNT THE VSM MODULES
TO THE METAL BASE PLATE
WITH THE BLACK PLASTIC
MOUNTING CONNECTORS
SUPPLIED WITH THE KIT.
CONNECT THE FLAT CABLE SUPPLIED
WITH THE KIT FROM THE I/O BOARD TO
THE VARIABLE SPEED MODULES AS SHOWN
SWITCHES SET FOR VAR SP #1
SWITCHES SET FOR VAR SP #2
DO NOT ROUTE ANY
OTHER WIRES THAN
THOSE SHOWN THROUGH
THE CONDUIT.
USE THE SHORT PVC
CONDUITS SUPPLIED
WITH THE KIT TO CONNECT
THE PB 20'S TO THE
CONTROL.
DO NOT MOUNT THE
PB 20'S FARTHER AWAY
THAN THE CONDUITS
WILL ALLOW.
  • Page 1 1
  • Page 2 2

Chore-Time MT2330A CHORE-TRONICS® 20 Amp Variable Speed Kit Operating instructions

Brand
Chore-Time
Model
MT2330A CHORE-TRONICS® 20 Amp Variable Speed Kit
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents