The Ultimate Connection
Continental
®
Continental Industries, Inc. Tel. 800.558.1373 www.conind.com
4102 S 74th East Ave Tel. 918.627.5210 www.thermoweld.com
GAS • PROPANE • PLUMBING • WATER DISTRIBUTION • CATHODIC PROTECTION
34-6034-69
ECN 2363 REV "B" 7/27/10
INSTALLATION INSTRUCTIONS
CONDUCTIVE COMPRESSION X PE COMPRESSION COUPLINGS
CONDUCTIVE COMPRESSION END
3/4" IPS & LARGER
1. CLEAN METALLIC PIPE ENDS THOROUGHLY. REMOVE ANY
COATINGS, DIRT, ETC.
2. LOOSEN COMPRESSION NUT AND INSERT PIPE UNTIL IT
BOTTOMS IN COUPLING. PIPE MISALIGNMENT SHALL BE
NO MORE THAN 3 ½°.
3. TIGHTEN CONDUCTIVE COMPRESSION NUT TO THE
TORQUE VALUES LISTED.
Size Torque
Ftlbs
Metallic Pipe Pullout
Reistance
3/4" IPS 120-140 575 lbs
1" IPS 120-140 900 lbs
1 1/4" IPS 280-300 1,000 lbs
NOTE: THE CONDUCTIVE COMPRESSION END IS NOT A FULL
RESTRAINT JOINT. WHERE PIPE PULLOUT COULD OCCUR, THE
PIPE JOINT MUST BE ANCHORED.
PE COMPRESSION END
4. VERIFY THAT THE COUPLING IS THE CORRECT SIZE FOR
THE POLYETHYLENE PE PIPE. VERIFY THE SDR OR
WALL THICKNESS OF THE PIPE MATCHES THE SDR OR
WALL THICKNESS STAMPED ON THE END OF THE
STIFFENER.
5. CUT PE PIPE ENDS SQUARE, DEBURR INSIDE AND
OUTSIDE, CLEAN THOROUGHLY TO ASSURE THERE IS NO
DIRT, GREASE, OIL, ETC. ON ASSEMBLY AREA OF PIPE.
6. MARK STAB LENGTH ON PE PIPE SEE EXAMPLES FOR
CORRECT PIPE OR TUBING SIZE AND CORRESPONDING
STAB LENGTH.
7. LOOSEN COMPRESSION NUT AND INSERT PE PIPE UNTIL IT
BOTTOMS IN COUPLING.
8. TIGHTEN COMPRESSION NUT UNTIL IT SHOULDERS
AGAINST THE COUPLING. LINE MARKED FOR STAB
LENGTH SHOULD BE NO MORE THAN 3/16" FROM FACE OF
NUT, IF NOT, REASSEMBLE.
9. TO ASSURE PROPER ASSEMBLY AND TO COMPLY WITH
49 CFR 192 SUBPART JTEST REQUIREMENTS, THE JOINT
SHALL BE LEAK TESTED.
3/8" OD, 5/8" OD
7/ 8" OD, 1/2" IPS
1 11 /16" STAB LENGTH
1 1/ 8" OD, 3/4" IPS
1" IPS, 1 1/4" IPS
1 7/ 8" STAB LENGTH
IMPORTANT
For use on:
Polyethylene (PE) gas pipe meeting
the requirements of ASTM D 2513
Pressure Rating: 125 psig MAOP
Operating Temperature: -20 to 140° F
Material: Carbon Steel
-
1
Continental Industries 5657-53-1015-00 Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Continental Industries (CI) 0000-34-7144-29-adapter-coupling Installation guide
-
Carf-Models Extra 300SX 2.6m Owner's manual
-
HOME-FLEX 18-406-007 Installation guide
-
-
-
-
Charlotte Pipe PVC 00304 1200 User manual
-
AeroWorks 60cc Freestyle 260 ARF QB-L Assembly Manual
-
-
