80% done!
Excited to see your laser cutter begins to take shape!
Success is just around the corner!
There are four holes designed for cable ties on the right
plate. Do not attach cable ties in the specified two hole.
They may interfere with the moving of the laser module.
The 2-pin port is designed for the
40 W laser module.
You don't need to use it for other
laser modules.
Insert the TF card before using xTool D1 Pro. Otherwise, some
functions may fail, such as Wi-Fi connection-based processing,
offline processing, and Framing in processing preview.
Meet your xTool D1 Pro
Emergency stop switch
Wi-Fi antennaKey
2827
Emergency stop
If errors or machine faults occur during material processing,
you can press the emergency stop switch to power off the
machine and stop the processing.
Emergency stop
You can turn the emergency stop switch to reset it.
3029
You can insert the key to unlock the
processing and related functions.
Operation access control
To prevent others from using your machine,
you can remove the key to lock the processing
and related functions.
3231
Adjust the tension of the timing belt on the right plate
Set up xTool D1 Pro
Try to set the tension of the timing belt on the right plate to be the
same as that of the timing belt on the left plate to ensure better
engraving and cutting results.
/
