2. Computers & electronics
  3. TVs & monitors
  4. Wall & ceiling mounts accessories
  5. Rigid Industries
  6. 20641

Rigid Industries 20641 Installation guide

  • Hello! I've reviewed the installation instructions for the Rigid Industries Ignite Flush Mount Back Up Light Kit. This document provides guidance on mounting the lights and connecting them to your vehicle's electrical system. It covers the necessary steps for a successful install, including hole preparation, wiring connections, and testing. I'm ready to assist with your questions about the product.
  • What size hole saw is needed for the main hole?
    What size drill bit is needed for the mount screw holes?
    Where should the lights be installed?
IGNITE FLUSH MOUNT
BACK UP LIGHT KIT
INSTALLATION INSTRUCTIONS
Always disconnect any power sources connected to your vehicle
before servicing fuses or electrical systems. Professional installation is recommended.
Note: location should be a ξ€Ÿat vertical surface on the rear of the vehicle.
WARRANTY INFORMATION
For warranty information, visit www.rigidindustries.com/about/warranty
779 N Colorado St, Gilbert, AZ 85233 β€’ 855-760-5337
www.rigidindustries.com
Ignite, and Rigid Industries are registered and/or common law marks owned by JST Performance, LLC,
a Delaware limited liability company d/b/a Rigid Industries.
1. Use 1.75” diameter hole saw for main hole. Place light into hole and mark locations for
mount screws. Use 3/16” drill bit for mount screw holes.
2. Install lights using provided hardware.
3. Wiring: Route cables behind bumper, trim excess, connect to factory reverse light wires.
Take care to avoid any heat sources & sharp or abrasive surfaces.
4. Reconnect power source, place your vehicle in reverse and ensure lights turn on.
Use This Template For
Accuracy When Using Hole Saw
/