2. Home
  3. Home security & automation
  4. Security device components
  5. Cell2
  6. WLK
WLK

Cell2 WLK User manual

  • Hello! I've reviewed the user manual for the 8-inch Round Interior Light. This document covers the installation, wiring, and operation of the light, including its bright and dim modes. I'm ready to answer any questions you have about using and setting up this device.
  • What are the two operating modes of the light?
    What color wire should be connected to +12VDC for Bright Mode?
    What is the required cut-out size for installation?
OPERATION
NOTE: Bright Mode has priority over Dim Mode.
Each unit may be operated in one of the two modes:
Operating in Bright Mode:
With the black wire connected to chassis ground, connect the red wire
to +12VDC to illuminate the light at full intensity (Bright mode).
Operating in Dim Mode:
With the black wire connected to chassis ground, connect the white
wire to +12VDC to illuminate the light in Dim Mode.
To properly install this light, you must have a good understanding of automotive electrical
procedures and systems, along with proficiency in the installation and use of safety
warning equipment.
INSTALLATION
1. Create a Ø7.00″ (178mm) cut-out on the selected mounting surface.
2. Make all wiring connections.
3. Push the 4 snap-springs inward, and insert the light into cut-out;
the snap-springs will fix the light into the position.
4. Test for proper operation.
A
B
To +12VDC for Bright Mode (fuse @ 1.5A)......... RED
To +12VDC for Dim Mode (fuse @ 1.5A).........
To -Chassis Ground........................................ BLACK
WIRING
Ø7.00″
(178mm)
push the snap-springs
A
BInser t the Light
8-inch Round Interior Light MANUAL
/