Highwood Brockton Lamppost Assembly Instructions

Hello! I've reviewed the Assembly Guide for the highwood Garden Collection Brockton Lamp Post. This document provides step-by-step instructions for installing the post, including how deep to dig the hole, the amount of gravel needed, and how to ensure the post is plumb. It also specifies the maximum lamp base size of 5.25" X 5.25". I am ready to answer your questions about the lamp post and its installation.
How deep should the hole be dug?

How much gravel is needed for drainage?

What is the maximum lamp base size?

For information on Care and Cleaning or to register your

highwood product, please visit www.highwood-usa.com. PAGE 1 OF 1

highwood

NATURE'S CLOSEST RIVAL



IMPORTANT! Check for underground services with your local

authorities BEFORE installation of this product.

Garden Collection

Brockton Lamp Post

Assembly Guide

1) Dig a Hole Approximately

21" Deep. Thread Your

Power Wire Through the Post.

Fill the Hole With Approximately

3" of Gravel for Water Drainage.

2) Insert the Base of the Post

Into the Hole and Fill With

Concrete or Packed Stone Dust.

Using a Hand Level,

Ensure the Post is Plumb on All Sides.

LMPT1

11.03.17

3) Attach any lamp to the top

of your new lamppost using

universal brackets or by following

the instructions/brackets

supplied with the lamp itself.

NOTE: The maximum lamp base

size is 5.25" x 5.25".

PULL WIRE

THROUGH

LEVEL

POWER

(INSTALL PER

LOCAL CODES)

GRAVEL

GROUND LEVEL

FILL