CTA PAD-SICCB109 Owner's manual

Brand: CTA

Model: PAD-SICCB109

Type: Owner's manual

888-733-4448

PAD-SICCB

INSTALLATION - MANUAL

INSTALLATION:

1. Inserting Tablet into Enclosure

Wireless Inductive Charging Case w/ Security Lock

E F

CONTENTS:

Once the tablet device is inside, plug

the charging cable into the power

socket. Then place the internal front

(hard) cover on top of the case, and

gently clip all four sides shut.

Tighten the anti-theft screw with

the included star key (C) if you

want the case security.

Reinstall the external silicone

rubber sleeve.

Peel the external silicone sleeve

from the internal hard case using

component (F).

To open case, apply gentle pressure to

the small clips (noted on the diagram by

arrows). The internal hard case will

open when all four sides are unclipped.

Insert the iPad into the back

portion of the hard cover.

2. Setting the Cover in Tabletop or Handheld Mode

1. Locate kickstand at case (A) rear and fold out underneath strap.

2. Display tablet at desired viewing angle.

3. Press kickstand in to return to handheld mode.

3. Charging the Tablet Device

Connect the AC/DC power supply to the charging plate as shown above. Make sure that the

charging case and the

back charging plate

are aligned properly.

You should see a blue

indicator lighting up

on the back of the

charging plate.

The blue indicator light indicates that the

tablet device is properly connected to

the inductive charging plate.

There should be a power level

indicator on the tablet screen.

4. Using with kiosk stand (ADD-ICCSTAND)

4A. Place component (E) in the

(4) outter holes in the back of

the charging plate.

4B. Align VESA holes of the charging plate (B) and

the stand, and rotate in (4) screws (D) using the

included allen key (C) until securely tightened.

4C. Place the tablet device

on top of the charging plate

by aligning the magnets.

5. Key & Lock Security Option

5A. Easily Click-in Cable lock (D) into security hub to secure device. 5B. To release cable-lock insert provided Key

(E) into lock cable (D) and turn it clockwise

then take out the cable lock.

6. How to Anchor Into Table 7. ADD-ON Option

6A. Take the looped end of lock cable (D) and turn it around leg

table then click-in head of lock cable into the security hub. 7A. Attach Add-On into threaded holes (x4) when needed,

such as card readers, led lights, etc. As shown above.

CTA PAD-SICCB109 Owner's manual

CTA PAD-SICCB109 Owner's manual

CTA PAD-SICCB109 Owner's manual

Related papers

Other documents