CARBON MONOXIDE DETECTOR

ART. 30009006

Specifications:

• Power supply: 12V DC

• Current absorption: 150mA max (110mA in stand by)

• Operating temperature: from 0°C to +55°C

• Operating humidity: 95% max (NOT condensing)

• Dimensions (L x H x W): 70 x 115 x 44 mm

• Standard accords: combustible gas detector GB15322-2003

General view:

This household carbon monoxide detector adopt SM

advanced gas sensor that enables detecting the gas in

time and then send out the alarm signal.

Connections:

Note: avoid installing the detector close to the following sources of interference: near the cooker, direct air flow

form vents, fans, doors, windows, sources of steam, oil vapor, etc.

Operating instructions:

• Choosing a suitable position to install the detector according to the INSTALLATION

• With 12V DC power supply and after the warm-up (the green LED flashes per second for 2 minutes), the

• Choosing a suitable position to install the detector according to the INSTALLATION. Connect the external

• With 12V DC power supply and after the warm-up (the green LED flashes per second for 2 minutes), the

detector comes into normal detecting state

2 - While detected the carbon monoxide, the red LED flashes, the buzzer sends out the alarm sound and the

relay will be activate. The detector will resume to the detecting state when the gas density is lower than the

4

- If the detector runs disorderly, cut the power off and rerun again. If still in error, please contact the installer.

Test:

To test the detector, you can give some gas around in distance of 5cm to the gas convection windows by using

an ignition lighter. Gas testing frequently may result in reducing the sensitivity of the detector. The alarm

density of gas is set according with the criteria of GB15322-2003. The detector will stop alarm and resume

the detecting state while the gas density reduced.

Led information:

RED LED FLASH

Gas leak

GREEN LED FLASH Warm-up

Inside error

Maintenance:

The user must brush and clean the gas convection windows with a little of cleanser every three months, avoid

exhaust)

• Avoid to use the stimulus near the detector (e.g.: fixature, insecticide, oil paint)

• Avoid to disassembly the detector by yourself

• For various reasons, including, but not limited to, changes in environmental conditions, electric or

electronic disruptions and tampering, the product may not perform as expected. The user is advised to

take all necessary precautions for his/her safety and the protection of his/her property.

Emergency treatment:

• Shut down the tube valve right away

• Open the window and make the air flow rapidly

Via Don Arrigoni, 5 24020 Rovetta S. Lorenzo (Bergamo)