Page is loading ...
Heater Towel Warmer 2 in 1 (Aluminium)
Model : S852E
Installation and Operating Manual
FREESTANDING
1. Remove the towel warmer from the carton and make sure no parts are missing. (see list)
2. Remove the wall-mounting clips, screws, and dry wall anchors and store in case you wish to use
them later.
3. Locate the two (2) legs and four (4) screws required for assembly.
4. Position the legs in place and put the screws through the hole in the leg and screw tightly into the
bottom rail. (see picture)
5. Place the towel warmer on level ground and make sure it is sturdy and doesn’t rock. You can
make slight adjustments by loosening the screws, moving the legs and retightening.
6. Plug the cord into a 120V outlet and turn the switch to ON, the pilot light will illuminate. After a
short time the towel warmer will reach its operation temperature of 122F. Temperature will vary
depending on the temperature of the surroundings.
7. Switch OFF when not in use.
WALL-MOUNT
1. Remove the towel warmer from the carton and make sure no parts are missing. (see list)
2. Remove the two legs and four screws and store in case you wish to use them later.
3. Locate the four (4) wall-mounting clips, eight (8) screws and eight (8) dry wall anchors.
4. Place the towel warmer against the wall, position and mount. Measure all dimensions prior to
rough-in and installation. (see picture)
5. Plug the cord into a 120V outlet and turn the switch to ON, the pilot light will illuminate. After a
short time the towel warmer will reach its operation temperature of 122F. Temperature will vary
depending on the temperature of the surroundings.
6. Switch OFF when not in use.
PARTS FOR WALL-MOUNT
Eight (8) drywall anchor
Eight (8) screws
Four (4) brackets
PARTS FOR FREESTANDING
Two (2) legs
Four (4) screws
ΔCAUTION:
Read this entire instruction manual thoroughly before beginning installation.
Do NOT use an abrasive or chlorine-based cleaner on the Towel Warmer. A mild detergent,
used with a soft, damp cloth, will restore most units to their original luster.
Never place your Towel Warmer inside a shower, sauna or steam room or immerse in water
for any reason.
To provide continued protection against risk of electric shock, plug the unit into properly
grounded outlets only.
UL Approved for Household use only; do NOT use outdoors.
Never operate any electrical appliance with a damaged cord or plug.
To dry clothing, drape a cotton towel over the rails then drape your clothes over the towel. Be
sure that all garments you wish to dry this way are colorfast and free of detergents or residues
that may cause discoloration.
WARNING:
Your Towel Warmer is NOT a toy. It will heat up and may appear hot to the touch. It is safe
to leave your towel warmer running continuously 24 hours a day, but it should be used
responsibly at all times. Switch OFF when not in use.
Never stand, sit, or hang on the Towel Warmer unit.
CHILDREN
Never allow children to play on or with the Towel Warmer. Close supervision is necessary
when using any electrical appliance by or near children.
/
