Hunter Fan 50016 Installation guide

50016
Brand
Hunter Fan
Model
50016
Type
Installation guide
1
MA059 r091317
Remove the globe by lifting and
turning counterclockwise one third
of a full turn of the glass. Cautiously
lower the glass and set aside.
Remove the two bulbs. Set the
bulbs aside.
Remove the three switch housing
assembly screws.
Contempo Service Kit Instructions
Removing Your Existing Light Kit
Lower the light kit assembly.
Disconnect the plugs.
Remove the screw from the
non-keyhole slot. Loosen the
two remaining screws.
Keyhole
Rotate the upper switch
housing clockwise to disengage
from the two screws. Set aside
the upper switch housing.
Remove the two remaining screws.
DISCARD ALL COMPONENTS (except for the bulbs).
You will replace all components with new hardware.
You will re-use the bulbs.
2
Attach the globe by lifting and
turning clockwise a quarter of a full
turn or the glass until it stops.
NOTE: Check to ensure proper
engagement.
Install the LED bulbs into the sockets.
When necessary, replace with bulbs
of same wattage.
Bulb
Lift the globe and align the
notches in the globe with the tabs
in the light kit.
Tab
Notch
Align the screw holes in the upper
switch housing assembly with the
screw holes in the light kit assembly.
Screw
Holes
Install three switch housing
assembly screws, found in the
hardware bag. Tighten all three
screws securely.
Connect the plugs from the upper
and lower switch housings. Make
sure to line up the colored markings
on the connectors.
Screw two housing assembly
screws from the hardware bag
halfway into the motor housing. It
does not matter which two screw
holes you choose.
Insert the third screw, found in the
hardware bag, into place and
tighten all three screws securely.
Feed the 9-pin wire plug through
the center hole of the upper
switch housing, then wrap keyhole
slots around the screws and twist
counterclockwise.
Note: Remove the shipping
ring before installing the
switch housing. See page 6
for more details.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure the
lower switch housing to the upper switch housing
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Contempo Service Kit Instructions
Installing Your New Light Kit
ONLY INSTALL HARDWARE AND COMPONENTS included
with your service kit. You will re-install the bulbs.
  • Page 1 1
  • Page 2 2

Hunter Fan 50016 Installation guide

50016
Brand
Hunter Fan
Model
50016
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents