Legrand Satellite Surge Suppressor - 364746-01 Installation guide

301 Fulling Mill Road, Suite G

Middletown, PA 17057

Phone (800) 321-2343 / Fax (717) 702-2546

www.onqlegrand.com

Page 1 of 1

INSTRUCTION/INSTALLATION SHEET

SATELLITE SURGE SUPPRESSOR

IS-0285 REV. A

1. Introduction

The On-Q/Legrand Satellite Surge Suppressor, P/N

364746-01, protects the home’s satellite products

from voltage spikes. It can be mounted on the On-Q

RF Coax Conditioning Module, P/N 364679-01, (see

Figure 1) which is typically installed in an On-Q

enclosure or placed in-line on a coaxial satellite feed

line.

2. Description

The On-Q Satellite Surge Suppressor features non-

degrading performance over time, low (65V)

clamping voltage, 500 Ampere surge capability and

no voltage overshoot. Its response time is 1

nanosecond and it is self-resetting. Both ends of the

Satellite Surge Suppressor contain female “F” style

connectors. One female end can be unscrewed to

expose a male “F” style connector.

3. Installation

NOTE: If applicable, refer to IS-0232 for specific installation instructions concerning the RF Coax

Conditioning Module.

A. Secure the Satellite Surge Suppressor to the RF Coax Conditioning Module mounting tab using the provided

retaining hex nut, if applicable (as shown in Figure 1).

B. Attach the satellite feed cable to the Satellite Surge Suppressor.

C. Connect the other end of the Satellite Surge Suppressor to the satellite or auxiliary inputs of the video distribution

module.

NOTE: Plan installation so that coaxial cable bends are not less than 2” radii for RG6 Quad Shield Coaxial

Cable.

Figure 1