Woodford 17C-10-MH Installation guide

Type
Installation guide
For more information contact…
WOODFORD MANUFACTURING COMPANY
2121 Waynoka Road, Colorado Springs, Colorado 80915 • Phone: (800) 621-6032 • Fax: (800) 765-4115
To view our complete product line visit: www.woodfordmfg.com
or email: [email protected]
A Division of WCM Industries, Inc.
O
V
E
H
O
O
R
S
Y
E
M
E
D
F
O
R
D
O
O
R
W
C
E
E
E
T
M
A
R
Z
E
F
R
S
U
T
B
U
A
F
D
N
A

Fastener
Rev 05/10 Form No. II17.102
Wall faucets must be properly installed and operated to
insure drainage. Improperly installed or operated wall
faucets may freeze and burst in freezing weather.
INSTALLATION INSTRUCTIONS:
1. Before installation, flush supply line to remove any
debris.
2. Drill a 1-1/8” diameter hole through the wall in the
desired location and insert the faucet from the
outside. FIGURE 1
3. Install with nozzle pointing down. FIGURE 1
4. From inside the building, the alignment mark on
the tube can be used to correctly align the faucet
when the mark is pointed down. FIGURE 1
5. The tube must have a slight downward pitch for
proper drainage. FIGURE 1
6. For solder connection, open faucet to full open
position before soldering. Excessive heat can
damage valve seat rubber or stainless steel seat
and factory solder joint.
7. Secure faucet to the wall using appropriate
fasteners installed through the holes in the flange.
Adjustable flange matches slope of siding.
FIGURE 2
NOTE: The packing nut, located behind the handle, has
been factory adjusted. If leakage should occur after
installation or use, the packing nut can be tightened to
stop the leak. FIGURE 1
Model 14
No anti-siphon protection
Model 17
Anti-siphon protected.
Model 14 & 17
Freezeless Wall Faucet
FIGURE 2
Refer to important
reminder on Wall
Flange.
FIGURE 1
Downward Pitch
1-1/8” Dia. Hole
Alignment Mark
Packing Nut
Nozzle
  • Page 1 1

Woodford 17C-10-MH Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI