Gronomics LT 24-72 Operating instructions

Type
Operating instructions
www.gronomics.com East Bethel, MN USA 763-753-7374
Continued
Ladder Trellis Kit
(24”W x 72”H) Assembly Instruction
1
Parts Identi cation
If any pieces are missing or replacement parts are
required, contact Gronomics at 1-855-299-6727.
NOTE: To unfold the trellis, hold the trellis upright and
place hands as shown and pull apart.
NOTE: The trellis can be placed directly in the soil or can
be secured into any raised or elevated garden beds.
LT 24-72
Packaged & Inspected by: Date:
1
1
Parts List
ITEM QTY. PART # DESCRIPTION
1 2 LT24-72 Folding Trellis, 24”W x 72”H
2 4 CS8-112ZY Screw, #8 x 1-1/2” GRK
Torx® T15
2
Place one trellis (Item 1) on the ground with the
Logo facing down.
Place the other trellis with the Logo facing up on
top of the trellis on the ground.
Install a #8 x 1-1/2” screw (Item 2) into the pre-
drilled hole on each trellis.
NOTE: Do not over tighten the screws.
Trellis Ladder Assembly
2
Pre-drilled Hole
On Bottom
Trellis
Pre-drilled Hole
On Top Trellis
1
2
www.gronomics.com East Bethel, MN USA 763-753-7374
Stand the trellis ladder upright and spread the bottom of the trellis ladder
approimately 24” apart.
NOTE: The trellis ladder can be placed directly into the soil or secured to
any raised or elevated garden bed.
Trellis Ladder Assembly (Continued)
3
Place the trellis (Item 1) into garden bed as shown. Align the bottom of
the trellis with the bottom of the top side rail, center the trellis between
the posts and make sure the trellis is straight.
Install four #8 x 1-1/2” screws (Item 2) into the pre-drilled holes.
Trellis Ladder Installation Options (Continued)
5
2
2
The trellis ladder can be separated and the two trellises can be mounted
into the ground or installed onto any raised or elevated garden bed.
Steps 4 - 6 show three con gurations, create your own con guration.
Place the trellis (Item 1) into garden bed as shown. Align the bottom of
the trellis with the bottom of the top side rail, center the trellis between
the posts and make sure the trellis is straight.
Install four #8 x 1-1/2” screws (Item 2) into the pre-drilled holes.
Trellis Ladder Installation Options
4
2
2
Place the trellis (Item 1) into garden bed as shown. Align the bottom of
the trellis with the bottom of the top side rail, center the trellis between
the posts and make sure the trellis is straight.
Install four #8 x 1-1/2” screws (Item 2) into the pre-drilled holes.
Trellis Ladder Installation Options (Continued)
6
2
2
  • Page 1 1
  • Page 2 2

Gronomics LT 24-72 Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI