2. seeed studio
  3. reComputer

seeed studio reComputer Installation guide

  • Hello! I've reviewed the provided Assembly Guide for the seeed studio reComputer Industrial. This guide provides detailed, step-by-step instructions for assembling the device, covering everything from removing the initial screws to installing modules and enclosing the system. I'm ready to address your questions about the assembly procedures or device features.
  • How many screws need to be removed from the bottom in Step 1?
    What should be done after removing the side panels?
    How many screws are used to lock the carrier board?
    Where is the LoRaWAN module inserted?
    Where is the 4G/5G module inserted?
12 3 4 5
KM3.0 x L32.0 120°-KM3.0 x L5.0 CM3.0 x L4.0 CM2.0 x L3.0 Stud-M3 x 6.5+M2 x 2.0
reComputer Industrial
Assembly Guide
Step 1
Remove the four screws from the bottom.
1 x4
Step 2
Remove the two side panels.
Step 3
Remove the rear case.
Step 4
Remove the four fixing screws of the carrier board.
2 x4
Step 5
If you need to replace the SSD, remove the screws,
and gently remove the SSD module.
3 x1
SSD
Step 6
If you need to install a LoRaWAN® module, insert the LoRaWAN® module
into the Mini PCIe interface (lower interface) and lock it with two screws. If
you need to install a 4G/5G module, insert the 4G/5G module into the M.2
Key B interface (upper interface) and lock it with one screw. Please note that
only one module can be installed at a time on these two interfaces
4 x2
3
x1
5
x1
Mini PCIE
5G/4G
Step 7
Install the carrier board and lock it with four screws.
2 x4
Step 8
Install the rear case.
Step 9
Install the two side panels
Step 10
Lock them with four screws.
1 x4
Step 11
/