LPG Series
User Manual
Rev Date: V2 03/31/2021Rev Date: V2 03/31/2021
Specications
Safety and Notes
Installation
LED Parking Garage Light
Important: Read all instructions prior to installation.
Model LPG-50K55P LPG-50K75P
Operating Temperature -4°–113° F(-20°–45° C)
IP Rating IP65
Fixture Weight 5.3 lb (2.4 kg) 7.71 lb (3.5 kg)
• This product should be installed by a fully certied electrician in
accordance with local building and electrical codes.
• Due to risk of electric shock, ensure that the main power source and
circuit breakers are switched o before performing any installation or
wiring procedures.
• Failure to properly support the xture during installation may cause
damage or injury, for which the manufacturer is not responsible. Ensure
the mount is securely attached and will support the weight of the xture.
UNSCREW LOCK SCREWS
OPEN LID AND SLIDE OFF CHASSIS
DRILL HOLES THROUGH TEMPLATE
AND MOUNT TO J-BOX
HANG LIGHT ON FIXTURE BASE
CONNECT WIRING
CLOSE LID AND TIGHTEN LOCK SREWS
ALTERNATE: MOUNT TO CEILING
AND WIRE THROUGH CONDUIT
Wiring Diagram
Line
Neutral
Ground
Black
L L
N N
GND GND
White
Dim (+)
Dim (-)
Purple
+ +
- -
Gray
Green
Line
Neutral
Ground
Black
L L
N N
GND GND
White
Dim (+)
Dim (-)
Purple
+ +
- -
Gray
100–277 VAC Input
0–10 Dimming
Check product label for specific electrical
specifications related to installation.
Improper installation will void warranty.