2. Renkforce
  3. 2583518
2583518

Renkforce 2583518 User guide

  • Hello! I've reviewed the user guide for the 3D Printer Pro 6+. This document includes instructions for setting up the device, calibrating the z-offset, loading filament, and initiating a print job. I'm ready to assist you with any questions you may have regarding the device or instructions.
  • How do I start the preheating process?
    How to load the filament?
    How do I calibrate the Z-offset?
Insert the print bed and magnetic mat.
34
Remove the styrofoam pads
56
1. Install the spool holder.
2. Slide the lament spool onto the holder.
1. Insert the lament tube in the feeder.
2. Insert the lament tube into the extruder.
7
System
Tool Print
8
1. Connect the mains cable to the power inlet on the printer.
2. Flip the power switch into the position I to switch on. The display lights up.
Quick Start Guide
FDM 3D Printer Pro 6+
Item No. 2583518
Read the safety instructions supplied
with the product before using
1Set printer up 2Calibrate Z-Offset
Insert the print bed and magnetic mat.
Open the menu Tools.Touch the button Preheating to start the pre-
heating process.
Wait until the preheat temperature has been reached.
Open the menu Manual.Touch to move the extruder to its zero posi-
tion.
Activate the Z-offset calibration with the slider. Touch the distance increment 0.1 mm to
activate it.
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights including translation reserved.
Reproduction by any method, e.g. photocopy, microlming, or the capture in electronic data processing systems require the prior written approval
by the editor. Reprinting, also in part, is prohibited. This publication represents the technical status at the time of printing.
Copyright 2022 by Conrad Electronic SE. *2583518_V1_0822_02_mq_jh_en_(2)
3Load lament
Open the menu Tools.Open the menu Filament.
Touch the temperature display to preheat the
extruder.
Cut the lament at an angle and then feed it into
the feeder.
Touch the button E1 Load to load the lament
into the extruder.
Touch the button Stop as soon as molten lament ows from the nozzle.
4Print
CAUTION
Hot print bed
Touching hot print bed can cause burns
Let cool down before touching
1
System
Tool Print
2
Connect the USB memory stick that contains
the print le to the USB port.
Open the menu Print.
Body-Mido.gcode
Body-Mido.gcode
Body-Mido.gcode
Body-Mido.gcode
31
mm/s
16%
Z
191/190
51/50 100mm/s
04h07m 03h06m
K1-07-11.gcode
4
Select le to print. The printer starts printing.
5 6
After printing is complete, let the printer cool
down to room temperature.
Remove the magnetic mat.
Slide one sheet of A4 paper (80 g) between the
nozzle and the print bed.
Slide the paper back and forth while repeatedly touching the button or to lift or lower the
print bed. If you notice slight resistance between nozzle, paper, and print bed, touch the button
to nish the calibration.
Conrm the Z-offset calibration. Touch the button Leveling to start
“Auto-levelling”.
Wait for “Auto-levelling” to nish.
/