2. PDQ
  3. 6W199
6W199

PDQ 6W199 User manual

  • Hello, I've reviewed the provided installation instructions for the PDQ 6W199 Electrified Exit Device Trim. This document outlines the necessary steps for proper installation, including options for configuring fail-safe and fail-secure locking. I am ready to answer any questions you may have about this product and its installation process.
  • What is the default configuration of the trim?
    How do I configure the trim for Fail Safe operation?
    What is the minimum time power must be applied to the lock?
6W199 Electrified Exit Device Trim
INSTALLATION INSTRUCTIONS Phone: 833-2-PDQTEC | www.pdqlocks.com
639412 Rev0 – 3-21-22
1. REMOVE HEAD COVER
AND RAIL FILLER PLATE
• Remove (4) screws, push latch into
device to remove head cover
RAIL FILLER PLATERAIL FILLER PLATE
HEAD COVERHEAD COVER
2. REMOVE HOLDING SCREW
AND RAIL
• Remove screw securing backplate to rail
• Remove backplate from rail HOLDING SCREWHOLDING SCREW
3. INSTALL WIRE
SADDLES ONTO
BACKPLATE
• Secure (3) wire saddles to
backplate
4. CONFIGURE TRIM FOR FAIL
SAFE OR FAIL SECURE
• Fail Secure: Power to Unlock (Default)
• Outside trim is locked when power is
OFF, and unlocked when power is ON
• Fail Safe: Power to Lock (Cut White Loop)
• Outside trim is locked when power is
ON, and unlocked when power is OFF.
POWER WIRES ARE
BLUE OR YELLOW
WHITE LOOP
POWER WIRES ARE
BLUE OR YELLOW
WHITE LOOP
(3) Mounting Locations(3) Mounting Locations(3) Mounting Locations
RAIL
639412 Rev0 – 3-21-22
6W199 Electrified Exit Device Trim
INSTALLATION INSTRUCTIONS Phone: 833-2-PDQTEC | www.pdqlocks.com
5. INSTALL TRIM AND DEVICE
• Refer to trim and exit device installation
instructions and templates.
• For ISMC option only:
• Install nonpolar blue or yellow power
wires into positions 1 & 2 on housing
• If REX and/or LM option is selected,
install wires in existing housing on exit
device. Otherwise, install wires in
provided 8-pin housing
ELECTRICAL SPECIFICATIONS
Keep operating voltage at +/- 10% of rated voltage
Important Notes:
Power must be applied to lock for a minimum of 5 seconds. It may be necessary to adjust the default time
delay on your system. Device may not lock reliably if powered for less than 5 seconds
To convert from fail secure to fail safe, cut the white wire loop. No need to cover the cut wires. To revert to
fail secure, reconnect the white wires with a suitable wire nut for two 24AWG wires.
Kit includes components to safely route wires through 6300/6400 exit device. Failure to use this kit will
result in pinched wires.
Vin Max Inrush Current Standby Current
12-24 VDC 1.0A 5mA
12-24 VAC 1.0A 15mA
ISMC OPTION:
TERMINAL INSERTION
END SHOWN
/